FTM-8401C-SL2CG Datasheet, PDF (1/10 Pages) Source Photonics, Inc. – 100BASE-FX Spring-Latch SFP Transceiver

Nov 20, 2006
100BASE-FX Spring-Latch SFP Transceiver
(For 2km transmission with MCU version)
Members of Flexon^TM Family
Standard
Features
‹ Build-in PHY supporting SGMII Interface
‹ Build-in high performance MCU supporting
easier configuration
‹ 100BASE-FX operation
‹ 850nm VCSEL laser and PIN photo-detector
‹ 0.5m~2km transmission with MMF
‹ Standard serial ID information Compatible with
SFP MSA
‹ SFP MSA package with duplex LC connector
‹ With Spring-Latch for high density application
‹ Very low EMI and excellent ESD protection
‹ +3.3V single power supply
‹ Operating case temperature: 0 to +70°C
Applications
‹ Switch to Switch interface
‹ Switched backplane applications
‹ Router/Server interface
‹ Other optical transmission systems
‹ Compatible with SFP MSA
‹ Compatible with IEEE 802.3ah-2004
‹ Compatible with FCC 47 CFR Part 15, Class B
‹ Compatible with FDA 21 CFR 1040.10 and
1040.11, Class I
‹ Compatible with Telcordia GR-468-CORE
‹ RoHS compliance
Description
Fiberxon FTM-8401C-SL2CG SFP transceiver is
high performance, cost effective modules. It is
designed for 100BASE-FX applications from 0.5m to
2km with MMF.
The transceiver consists of two sections: The
standard SFP part and the PHY part.
FTM-8401C-SL2CG is built with SGMII interface.
The optical output can be disabled by a TTL logic
high-level input of Tx Disable. Tx Fault is provided to
indicate that degradation of the laser. Loss of signal
(LOS) output is provided to indicate the loss of an
input optical signal of receiver.
The standard serial ID information Compatible with
SFP MSA describes the transceiver’s capabilities,
standard interfaces, manufacturer and other
information. The host equipment can access this
information via the 2-wire serial CMOS EEPROM
protocol. For further information, please refer to SFP
Multi-Source Agreement (MSA).
Fiberxon Proprietary and Confidential, Do Not Copy or Distribute
Page 1 of 10