FTM-83X0C-X03G Datasheet, PDF (1/11 Pages) Source Photonics, Inc. – 10G 850nm XFP Transceiver

Nov. 27, 2006
10G 850nm XFP Transceiver
(Up to 300m transmission)
Members of Flexon^TM Family
‹ Compatible with FDA 21 CFR 1040.10 and
1040.11, Class I
‹ RoHS compliance
Description
Features
FTM-83X0C-X03G is a high performance, cost
effective module, which is optimized for 10G
Ethernet, supporting data-rate of 10.3125Gbps
(10GBASE-SR) or 9.953Gbps (10GBASE-SW), and
transmission distance up to 300m on 50μm MMF
(2000MHz.km).
‹ Support 10GE application at the data-rate of
9.953Gbps and 10.3125Gbps
‹ Up to 300m transmission distance on 50μm
MMF (2000MHz.km)
‹ 850nm VCSEL and PIN receiver
‹ XFI electrical interface
‹ 2-wire interface for integrated Digital Diagnostic
monitoring
‹ XFP MSA package with duplex LC connector
‹ Hot pluggable
‹ Very low EMI and excellent ESD protection
‹ +5V, +3.3V power supply
‹ Power consumption less than 1.5 W
‹ Operating case temperature: 0~+70°C
The transceiver consists of two sections: The
transmitter section incorporates an 850nm VCSEL,
driver and re-timer. The receiver section consists of
a PIN photodiode integrated with a transimpedance
preamplifier (TIA) and CDR.
The module is hot pluggable into the 30-pin XFI
connector. The high-speed electrical interface is
base on low voltage logic, with nominal 100 Ohms
differential impedance and AC coupled in the
module. The optical output can be disabled by
LVTTL logic high-level input of TX_DIS. Loss of
signal (RX_LOS) output is provided to indicate the
loss of an input optical signal of receiver.
Applications
‹ 10GBASE-SR at 10.3125Gbps
‹ 10GBASE-SW at 9.953Gbps
‹ Other optical links
Standard
The user can access transceiver monitoring and
configuration data via the 2-wire XFP Management
Interface. This interface uses a single address, A0h,
with a memory map divided into a lower and upper
area. Basic digital diagnostic (DD) data is held in the
lower area while specific data is held in a series of
tables in the high memory area.
‹ Compatible with XFP MSA
‹ Compatible with IEEE 802.3ae-2002
‹ Compatible with FCC 47 CFR Part 15, Class B
Fiberxon Proprietary and Confidential, Do Not Copy or Distribute
Page 1 of 11
Controlled Electronic Version. 24hrs Obsolete when printed out without authorization. Last printed 2/26/2007 10:45:00 AM