FTM-811XC-L03DG Datasheet, PDF (1/13 Pages) Source Photonics, Inc. – 10G 850nm SFP+ Transceiver

Nov. 30, 2007
？
10G 850nm SFP+ Transceiver
(With monitor function, up to 300m transmission)
Members of Flexon^TM Family
Standard
Features
‹ Support 10GE application at the data rate
9.95Gbps and 10.3125Gbps
‹ Up to 300m transmission distance on 50µm
MMF (2000MHz.km)
‹ 850nm high-speed VCSEL and PIN receiver
‹ CDR included
‹ SFI electrical interface
‹ 2-wire interface for integrated Digital Diagnostic
monitoring
‹ SFP+ MSA package with duplex LC connector
‹ Hot pluggable
‹ Very low EMI and excellent ESD protection
‹ Single +3.3V power supply
‹ Power consumption less than 1.0W
‹ Operating case temperature: 0~+70°C
‹ Compliant with SFF-8431
‹ Compliant with SFF-8472 Rev 10.1
‹ Compliant with IEEE 802.3-2005 10GBASE-SR
and 10GBASE-SW
‹ Compliant with FCC 47 CFR Part 15, Class B
‹ Compliant with FDA 21 CFR 1040.10 and
1040.11, Class I
‹ Compliant with Telcordia GR-468-CORE
‹ RoHS compliance
Description
FTM-811XC-L03DG is a high performance, cost
effective module, which is optimized for 10G
Ethernet, supporting data-rate of 10.3125Gbps
(10GBASE-SR) or 9.953Gbps (10GBASE-SW), and
transmission distance up to 300m on 50µm MMF
(2000MHz.km).
The transceiver consists of two sections: The
transmitter section incorporates an 850nm VCSEL,
driver. The receiver section consists of a PIN
photodiode integrated with a transimpedance
preamplifier (TIA) and a CDR.
Applications
‹ 10GBASE-SR at 10.3125Gbps
‹ 10GBASE-SW at 9.953Gbps
‹ Other optical links
The module is hot pluggable into the 20-pin
connector. The high-speed electrical interface is
based on low voltage logic, with nominal 100 Ohms
differential impedance and AC coupled in the
module. The optical output can be disabled by
LVTTL logic high-level input of TX_Disable. Loss of
signal (RX_LOS) output is provided to indicate the
loss of an input optical signal of receiver.
Fiberxon Proprietary and Confidential, Do Not Copy or Distribute
Page 1 of 13