|
FTM-3413C-SLCG Datasheet, PDF (1/10 Pages) Source Photonics, Inc. – 100BASE-LX/1000BASE-LX Spring-Latch SFP Transceiver | |||
|
Oct. 15, 2006
100BASE-LX/1000BASE-LX Spring-Latch SFP Transceiver
(For 10km transmission with MCU version)
Members of FlexonTM Family
 Compatible with FDA 21 CFR 1040.10 and
1040.11, Class I
 Compatible with Telcordia GR-468-CORE
 RoHS compliance
Features
 Build-in PHY supporting SGMII Interface
 Build-in high performance MCU supporting
easier configuration
 Support more link status monitor, such as CRC,
package counter and Far End Fault Indication
(FEFI)
 Dual data-rate of 100BASE-LX/1000BASE-LX
operation
 1310nm FP laser and PIN photo-detector
 0.5m~10km transmission with SMF
 Standard serial ID information Compatible with
SFP MSA
 SFP MSA package with duplex LC connector
 With Spring-Latch for high density application
 Very low EMI and excellent ESD protection
 +3.3V single power supply
 Operating case temperature: 0 to +70°C
Description
Fiberxon FTM-3413C-SLCG SFP transceiver is high
performance, cost effective module. It is designed
for Gigabit Ethernet for 100BASE-LX/1000BASE-LX
applications from 0.5m to 10km with SMF.
The transceiver consists of two sections: The
standard SFP part and the PHY part.
FTM-3413C-SLCG is built with SGMII interface. It
can operate as 100BASE-LX or 1000BASE-LX by
software configuration or rate select hardware pin.
independently
The optical output can be disabled by a TTL logic
high-level input of Tx Disable, and the system also
can disable the module via I2C. Tx Fault is provided
to indicate that degradation of the laser. Loss of
signal (LOS) output is provided to indicate the loss
of an input optical signal of receiver or the link status
with partner. The system can also get the LOS(or
Link)/Disable/Fault information via I2C register
access.
Applications
 Switch to Switch interface
 Switched backplane applications
 Router/Server interface
 Other optical transmission systems
Standard
 Compatible with SFP MSA
 Compatible with IEEE 802.3-2002
 Compatible with IEEE 802.3ah-2004
 Compatible with FCC 47 CFR Part 15, Class B
The standard serial ID information Compatible with
SFP MSA describes the transceiverâs capabilities,
standard interfaces, manufacturer and other
information. The host equipment can access this
information via the 2-wire serial CMOS EEPROM
protocol. For further information, please refer to SFP
Multi-Source Agreement (MSA).
Building-in high performance MCU in this module,
Host can more easily configure all functions of
FTM-3413C-SLCG.
Fiberxon Proprietary and Confidential, Do Not Copy or Distribute
Page 1 of 10
|
▷ |