FTM-3401C-SL10ICG Datasheet, PDF (1/10 Pages) Source Photonics, Inc. – 100BASE-LX Spring-Latch SFP Transceiver

October 15, 2007
100BASE-LX Spring-Latch SFP Transceiver
(For 10km transmission with MCU version)
Members of Flexon^TM Family
‹ Compatible with FCC 47 CFR Part 15, Class B
‹ Compatible with FDA 21 CFR 1040.10 and
1040.11, Class I
‹ Compatible with Telcordia GR-468-CORE
‹ RoHS compliance
Description
Features
‹ Build-in PHY supporting SGMII Interface
‹ Build-in high performance MCU supporting
easier configuration
‹ Support more link status monitor, such as CRC
error counter and Far End Fault Indication
(FEFI)
‹ 100BASE-LX operation
‹ 1310nm FP laser and PIN photo-detector
‹ 10km transmission with SMF
‹ Standard serial ID information Compatible with
SFP MSA
‹ SFP MSA package with duplex LC connector
‹ With Spring-Latch for high density application
‹ Very low EMI and excellent ESD protection
‹ +3.3V single power supply
‹ Operating case temperature: -40 to +85°C
Applications
‹ Switch to Switch interface
‹ Switched backplane applications
‹ Router/Server interface
‹ Other optical transmission systems
Standard
Fiberxon FTM-3401C-SL10iCG SFP transceiver is
high performance, cost effective modules. It is
designed for 100BASE-LX applications of 10km with
SMF. The transceiver consists of two sections: The
standard SFP part and the PHY part.
FTM-3401C-SL10iCG is built with SGMII interface.
The optical output can be disabled by a TTL logic
high-level input of Tx Disable, and the system also
can disable the module via I2C. Tx Fault is provided
to indicate that degradation of the laser. Loss of
signal (LOS) output is provided to indicate the loss
of an input optical signal of receiver or the link status
with partner. The system can also get the LOS(or
Link)/Disable/Fault information via I2C register
access.
The standard serial ID information Compatible with
SFP MSA describes the transceiver’s capabilities,
standard interfaces, manufacturer and other
information. The host equipment can access this
information via the 2-wire serial CMOS EEPROM
protocol. For further information, please refer to SFP
Multi-Source Agreement (MSA).
Building-in high performance MCU in this module,
Host can more easily configure all functions of
FTM-3401C-SL10iCG.
‹ Compatible with SFP MSA
‹ Compatible with IEEE 802.3ah-2004
Fiberxon Proprietary and Confidential, Do Not Copy or Distribute
Page 1 of 10