ICX074AL Datasheet, PDF (4/21 Pages) Sony Corporation – Diagonal 8mm (Type 1/2) Progressive Scan CCD Image Sensor with Square Pixel for EIA B/W Video Cameras

ICX074AL
Bias Conditions
Item
Supply voltage
Substrate voltage
adjustment range
Substrate voltage
adjustment precision
Protective transistor bias
Symbol
VDD
Min.
14.55
VSUB
9.0
Indicated
voltage –0.1
VL
Typ.
15.0
Indicated
voltage
∗2
Max.
15.45
18.5
Unit Remarks
V
V ^∗1
Indicated
voltage +0.1
V
DC Characteristics
Item
Symbol Min. Typ. Max. Unit Remarks
Supply current
IDD
10
mA
Input current
IIN1
1
µA ^∗3
Input current
IIN2
10
µA ^∗4
∗1 _{Indications of substrate voltage (VSUB) setting value}
The setting value of the substrate voltage is indicated on the back of image sensor by a special code.
Adjust the substrate voltage (VSUB) to the indicated voltage.
VSUB code — two characters indication
↑↑
Integer portion Decimal portion
The integer portion of the code and the actual value correspond to each other as follows.
Integer portion of code
Value
9ACdE fGh JK
9 10 11 12 13 14 15 16 17 18
<Example> "A5" → VSUB = 10.5V.
∗2 _{VL setting is the VVL voltage of the vertical transfer clock waveform, or the same power supply as the VL}
power supply for the V driver should be used.
∗3 _{(1) Current to each pin when 18V is applied to VDD, VOUT1, VOUT2, HIS, RG, CGG1, CGG2, GND and SUB}
pins, while pins that are not tested are grounded.
(2) Current to each pin when 20V is applied sequentially to Vφ1, Vφ2 and Vφ3 pins, while pins that are not
tested are grounded. However, 20V is applied to SUB pin.
(3) Current to each pin when 15V is applied sequentially to RG, Hφ1 and Hφ2 pins, while pins that are not
tested are grounded. However, 15V is applied to SUB pin.
(4) Current to VL pin when 25V is applied to Vφ2, Vφ3, POGφ, HIGφ1, HIG2, VDD, VOUT1 and VOUT2 pins or
when, 15V is applied to Vφ1, VHOLDφ, VOGφ, CGG1, CGG2, Hφ1, Hφ2, HHGφ1 and HHGφ2 pins, while VL
pin is grounded. However, GND and SUB pins are left open.
(5) Current to GND pin when 20V is applied to the RG pin and the GND pin is grounded.
∗4 _{Current to SUB pin when 55V is applied to SUB pin, while all pins that are not tested are grounded.}
–4–