XC-55 Datasheet, PDF (3/6 Pages) Sony Corporation – PROGRESSIVE SCAN CAMERA MODULE

LOCATION OF PARTS & OPERATION
C mount standard
NF mount standard
y
1N
1I
SIGNAL SWITCH
1/30 Non-Interlaced
1/60 Interlaced
r
12Pin Multiconnector
u
A
F
M
GAIN SWITCH
AUTO GAIN
FIXED GAIN
MANUAL GAIN
i
MANUAL GAIN
CONTROL VOLUME
Rear Panel
XC-55/55BB
Pin No.
1
2
3
4
5
6
EXTERNAL
HD/VD MODE
GND
+12V
VIDEO(G)
VIDEO OUT
HD(G)
HD IN
12P Multiconnector
INTERNAL
Pin No. ^EXTERNAL
SYNC MODE
HD/VD MODE
GND
7
VD IN
+12V
8 TRIGGER IN(G)
VIDEO(G)
9
TRIGGER IN
VIDEO OUT
10
GND
HD(G)
11
+12V
HD OUT
12
VD(G)
INTERNAL
SYNC MODE
VD OUT
TRIGGER IN(G)
TRIGGER IN
GND
+12V
VD(G)
q Lens mount (C mount)
A commercial C mount lens
as well as the Sony standard
lens can be used.
w Camera fixing reference hole
High-precision screw hole
machined on the lens mount
surface. The reference hole
can suppress the shift of an
optical axis to the minimum.
e Screw hole for tripod adaptor
installation (VCT-333I/55I)
r 12Pin Multiconnector
The 12Pin multiconnector is
connected to a DC IN/SYNC
(DC power/sync signal input)
CCXC-12Pxxx cable.
t Lens mount (NF mount)
Mount standard with flange
back of 12 mm developed by
Sony. The lens mount can
also be converted into a C
mount. (LO-999CMT)
y Signal switch
1N: Outputs all pixel data of a
CCD continuously in 1/30
seconds.
1l: Outputs all pixel data of a
CCD in 1/60 seconds x 2.
The output display appears
on the monitor as interlacing
of 2:1.
u Gain switch
A: Outputs a fixed level of
image according to the
brightness of asubject.
(Variable range: 0 to 18 dB)
F: Fixed gain 0 dB
The highest S/N ratio can
be obtained.
M: Variable gain (manual)
At the factory, the variable
gain is adjusted to the fixed
sensitivity for a standard
subject.
An image in the same level
can be obtained when two
or more XC-55/55BB are
used for an identical subject.
i The gain can be changed in
the range of 0 to 18 dB when
the gain switch is set to "M".