ICX077AL Datasheet, PDF (3/18 Pages) Sony Corporation – Diagonal 3.6mm (Type 1/5) CCD Image Sensor for CCIR Black-and-White Video Cameras

ICX077AL
Bias Conditions
Item
Supply voltage
Symbol
VDD
Min.
14.25
Substrate voltage adjustment
range
VSUB
5.0
Substrate voltage adjustment
precision
Indicated
voltage – 0.1
Protective transistor bias
VL
Typ.
15.0
Indicated
voltage
∗2
Max.
15.75
12.75
Unit Remarks
V
V ^∗1
Indicated
voltage + 0.1
V
DC Characteristics
Item
Symbol Min. Typ. Max. Unit Remarks
Supply current
IDD
Input current
IIN1
Input current
IIN2
3
5
mA
1
µA ^∗3
10
µA ^∗4
∗1 _{Indications of substrate voltage (VSUB) setting value}
The setting value of the substrate voltage is indicated on the back of image sensor by a special code.
Adjust the substrate voltage (VSUB) to the indicated voltage.
VSUB code – one character indication
↑
VSUB code
Code and optimal setting correspond to each other as follows.
VSUB code
—= 0 1 2 3 4 6 7 8 9 AC d
Optimal setting 5.0 5.25 5.5 5.75 6.0 6.25 6.5 6.75 7.0 7.25 7.5 7.75 8.0 8.25
VSUB code
E f G h J K LmNPRSUV
Optimal setting 8.5 8.75 9.0 9.25 9.5 9.75 10.0 10.25 10.5 10.75 11.0 11.25 11.5 11.75
VSUB code
WX Y Z
Optimal setting 12.0 12.25 12.5 12.75
<Example> "L" → VSUB = 10.0V
∗2 _{VL setting is the VVL voltage of the vertical transfer clock waveform, or the same power supply as the VL}
power supply for the V driver should be used.
∗3 _{1) Current to each pin when 16V is applied to VDD, VOUT, RG, CGG, GND (Pin 6), and SUB pins, while pins}
that are not tested are grounded.
2) Current to each pin when 20V is applied sequentially to Vφ1, Vφ2, Vφ3, and Vφ4 pins, while pins that
are not tested are grounded. However, 20V is applied to SUB pin.
3) Current to each pin when 15V is applied sequentially to Hφ1 and Hφ2 pins, while pins that are not
tested are grounded. However, 15V is applied to SUB pin.
4) Current to VL pin when 25V is applied to Vφ1, Vφ3, VDD, and VOUT pins or when, 15V is applied to Vφ2,
Vφ4, Hφ1, and Hφ2 pins, while VL pin is grounded. However, GND and SUB pins are left open.
5) Current to GND pin when 20V is applied to the RG pin and the GND pin is grounded.
∗4 _{Current to SUB pin when 55V is applied to SUB pin, while all pins that are not tested are grounded.}
–3–