ICX267AL Datasheet, PDF (13/26 Pages) Sony Corporation – Diagonal 8mm (Type 1/2) Progressive Scan CCD Image Sensor

ICX267AL
5. Dark signal
Measure the average value of the signal output (Vdt [mV]) with the device ambient temperature 60°C and
the device in the light-obstructed state, using the horizontal idle transfer level as a reference.
6. Dark signal shading
After measuring 5, measure the maximum (Vdmax [mV]) and minimum (Vdmin [mV]) values of the dark
signal output and substitute the values into the following formula.
∆Vdt = Vdmax – Vdmin [mV]
7. Lag
Adjust the signal output value generated by strobe light to 150mV. After setting the strobe light so that it
strobes with the following timing, measure the residual signal (Vlag). Substitute the value into the following
formula.
Lag = (Vlag/150) × 100 [%]
VD
V2A
Strobe light timing
Output
Light
signal output 150mV Vlag (lag)
– 13 –