SN8F2280 Datasheet, PDF (122/163 Pages) SONiX Technology Company – 8-Bit Micro-Controller

SN8F2280 Series
USB 2.0 Full-Speed 8-Bit Micro-Controller
11 SERIAL INPUT/OUTPUT TRANSCEIVER
11.1 OVERVIEW
The SIO (serial input/output) transceiver allows high-speed synchronous data transfer between the SN8F2280 series
MCU and peripheral devices or between several SN8F2280 devices. These peripheral devices may be Serial
EEPROMs, shift registers, display drivers, etc. The SN8F2280 SIO features include the following:
z Full-duplex, 3-wire synchronous data transfer
z TX/RX or TX Only mode
z Master (SCK is clock output) or Slave (SCK is clock input) operation
z MSB/LSB first data transfer
z SDO (P2.1) is programmable open-drain output pin for multiple salve devices application
z Two programmable bit rates (Only in master mode)
z End-of-Transfer interrupt
The SIOM register can control SIO operating function, such as: transmit/receive, clock rate, transfer edge and starting
this circuit. This SIO circuit will transmit or receive 8-bit data automatically by setting SENB and START bits in SIOM
register. The SIOB is an 8-bit buffer, which is designed to store transfer data. SIOC and SIOR are designed to
generate SIO’s clock source with auto-reload function. The 3-bit I/O counter can monitor the operation of SIO and
announce an interrupt request after transmitting/receiving 8-bit data. After transferring 8-bit data, this circuit will be
disabled automatically and re-transfer data by programming SIOM register.
SIO Interface Circuit Diagram
SONiX TECHNOLOGY CO., LTD
Page 122
Version 1.1