SCWL252010R47MTF Datasheet, PDF (5/5 Pages) Socay Electornics Co., Ltd. – Wire-wound Type Power Inductor

Wire-wound Type Power Inductor
SCWL252010 Series
Reliability and Test Condition
Test Item
Test Condition
Criteria
1. Solder temperature : 260±5℃
1. More than 95 % of terminal electrode
should be covered with new solder
Resistance to Solder Heat 2. Flux : Rosin
3. DIP time : 10±1 sec
2. No mechanical damage
3. Induction value should be within ±20 %
of the initial value
1. Reflow temperature : 245℃ It shall be
Soldered on the substrate applying 1. No mechanical damage
Adhesive Test
direction parallel to the substrate
2. Soldering the products on PCB after the
2. Apply force(F) : 5 N
pulling test force > 5 N
3. Test time : 10 sec
1. Temperature : -50 ~ +125℃ for 30
Temperature Cycle
minutes each
2. Cycle : 500 cycles
1. No mechanical damage
2. Induction value should be within ±20 %
3. Measurement : At ambient temperature
of the initial value
24 hours after test completion
1. Temperature : 85℃±5℃
Dry Heat Test
2. Test time : 500 hours
3. Apply current : full rated current
1. No mechanical damage
2. Induction value should be within ±20 %
4. Measurement : At ambient temperature
of the initial value
24 hours after test completion
1. Temperature : 60℃±2℃
Humidity Test
2. Humidity : 90 ~ 95 % RH
1. No mechanical damage
3. Apply current : full rated current
2. Induction value should be within ±20 %
4. Test time : 500 hours
of the initial value
5. Measurement : At ambient temperature
24 hours after test completion
SOCAY Electronics Co., Ltd.
Revision February 12, 2014
5/5
www.socay.com
@ SOCAY Electronics Co., Ltd. 2014
Specifications are subject to change without notice.
Please refer to www.socay.com for current information.