SCWL252010R47YTFQ Datasheet, PDF (4/6 Pages) Socay Electornics Co., Ltd. – Wire-wound Type Power Inductor

Wire-wound Type Power Inductor
SCWL252010XXXXQ Series
Soldering and Mounting
Soldering
Mildly activated rosin fluxes are preferred. SOCAY terminations are suitable for all wave and re-flow soldering systems. If hand
soldering cannot be avoided, the preferred technique is the utilization of hot air soldering tools.
Solder re-flow
Recommended temperature profiles for re-flow soldering in Figure 1.
Solder Iron (Figure 2):
Products attachment with a soldering iron is discouraged due to the inherent process control limitations. In the event that a
soldering iron must be employed the following precautions are recommended.
u Preheat circuit and products to 150 ℃
u 355 ℃ tip temperature (max)
u Never contact the ceramic with the iron tip
u 1.0mm tip diameter (max)
u Use a 20 watt soldering iron with tip diam eter of 1.0mm
u Limit soldering time to 4~5 sec.
Recommended PCB Board Pattern
L (mm)
2.9
G (mm)
0.8
H (mm)
2.4
SOCAY Electronics Co., Ltd.
Revision February 12, 2014
4/6
www.socay.com
@ SOCAY Electronics Co., Ltd. 2014
Specifications are subject to change without notice.
Please refer to www.socay.com for current information.