ESDP041206V12B0 Datasheet, PDF (3/4 Pages) Socay Electornics Co., Ltd. – ESD Array

ESD Array
ESDP041206V12B0
Environmental Specifications
Temperature Specifications
Item
Bias
Humidity
Thermal
Shock
Specifications Test Condition
Reference
IL≤ 10μA
90%RH, 40°C Rate
Voltage 12VDC
1000hrs
MIL-STD-202
Method 103
IL≤ 10μA
-40°C to +85°C，30 min. JIS C0025
cycle, 5 cycles
(1998)Test Na
High
Temperature
IL≤ 10μA
Rated Voltage, 85°C,
1000hrs
MIL-STD-202G
Method 108
Solder leach
Resistance
IL≤ 10μA
260°C, 10s
MIL-STD-202G
Method 210F
Vibration
IL≤ 10μA
The entire frequency
rage: 10-55Hz, 1.5mm
amplitude, 2 hours for
each of X,Y,Z directions
MIL-STD-202G
Method 201A
IL - Leakage current at rated voltage, the maximum leakage current was
measured after reliability test.
Soldering Parameters
Parameter
Value
Operating Temperature
-55 to +125
Storage Temperature
--55 to +125
Taping Package
Storage
Condition
Storage Temperature
Relative Humidity
Storage Time
5 to 40
<65
12 Max
Unit
°C
°C
°C
%RH
Month
TP
TL
TS(max)
Ramp-up
TS(min)
25
Preheat
Time to peak temperature
(t 25℃ to peak)
Critical Zone
TL to TP
Ramp-down
Time
Precaution for soldering
Note that this product will be easily damaged by rapid heating,
rapid cooling or local heating.
Do not give heat shock over 100°C in the process of soldering.
We recommend to take preheating and gradual cooling
Soldering gun procedure
Note the follows, in case of using solder gun for replacement.
1) The tip temperature must be less than 280 for the period
within 3 seconds by using soldering gun under 30W
2) The soldering gun tip shall not touch this product directly.
Soldering volume
Note that excess of soldering volume will easily get crack the
body of this product.
Reflow Condition
Pb free assembly
-Temperature Min (Ts(min))
Pre Heat -Temperature Max (Ts(max))
+150°C
+200°C
-Time (min to max) (TS)
60 -180 Seconds
Average ramp up rate ( Liquidus Temp TL)
to peak
3°C/Second Max
TS(max) to TL - Ramp-up Rate
3°C/Second Max
Reflow
- Temperature (TL) (Liquidus) +217°C
- Time (min to max) (TL)
60 -150 Seconds
Peak Temperature (TP)
Time within 5°C of actual peak
Temperature (TP)
Ramp-down Rate
260 +0/-5°C
20-40 Seconds
6°C/Second Max
Time 25°C to peak Temperature (TP)
8 minutes Max
SOCAY Electronics Co., Ltd.
Revision November 08, 2013
3/4
www.socay.com
@SOCAY Electronics Co., Ltd. 2013
Specifications are subject to change without notice.
Please refer to www.socay.com for current information.