EMC2103 Datasheet, PDF (47/84 Pages) SMSC Corporation – RPM-Based Fan Controller with HW Thermal Shutdown

RPM-Based Fan Controller with HW Thermal Shutdown
Datasheet
6.9
Critical Temperature Limit Registers
ADDR
19h
1Ah
1Bh
1Dh
R/W
R/W
once
R/W
once
R/W
once
R/W
once
REGISTER
External Diode
1 Tcrit Limit
External Diode
2 Tcrit Limit
External Diode
3 Tcrit Limit
Internal Diode
Tcrit Limit
Table 6.13 Limit Registers
B7
B6
B5
B4
B3
Sign
64
32
16
8
Sign
64
32
16
8
Sign
64
32
16
8
Sign
64
32
16
8
B2 B1
4
2
4
2
4
2
4
2
B0 DEFAULT
1
64h
(+100°C)
1
64h
(+100°C)
1
64h
(+100°C)
1
64h
(+100°C)
The Critical Temperature Limit Registers store the Critical Temperature Limit. At power up, none of the
respective channels are linked to the SYS_SHDN pin or the Hardware set Thermal/Critical Shutdown
circuitry.
Whenever one of the registers is updated, two things occur. First, the register is locked so that it cannot
be updated again without a power on reset. Second, the respective temperature channel is linked to
the SYS_SHDN pin and the Hardware set Thermal/Critical Shutdown Circuitry. At this point, if the
measured temperature channel exceeds the Critical limit, the SYS_SHDN pin will be asserted, the
appropriate bit set in the Tcrit Status Register, and the TCRIT bit in the Interrupt Status Register will
be set.
6.10 Configuration Register
Table 6.14 Configuration Register
ADDR R/W REGISTER
B7
B6 B5 B4 B3
B2
B1
B0
20h R/W Configuration MASK -
-
-
SYS3 SYS2 SYS1 APD
DEFAULT
00h
The Configuration Register controls the basic functionality of the EMC2103. The bits are described
below.
Bit 7 - MASK - Blocks the ALERT pin from being asserted.
„ ‘0’ (default) - The ALERT pin is unmasked. If any bit in either status register is set, the ALERT pin
will be asserted (unless individually masked via the Mask Register)
„ ‘1’ - The ALERT pin is masked and will not be asserted.
Bit 3 - SYS3 (EMC2103-2 only) - Enables the high temperature limit for the External Diode 3 channel
to trigger the Critical / Thermal Shutdown circuitry (see Section 5.1).
„ ‘0’ (default) - the External Diode 3 channel high limit will not be linked to the SYS_SHDN pin. If the
temperature meets or exceeds the limit, the ALERT pin will be asserted normally.
„ ‘1’ - the External Diode 3 channel high limit will be linked to the SYS_SHDN pin. If the temperature
meets or exceeds the limit then the SYS_SHDN pin will be asserted. The SYS_SHDN# pin will be
released when the temperature drops below the high limit. The ALERT pin will be asserted
normally.
Bit 2 - SYS2 (EMC2103-2 only) - Enables the high temperature limit for the External Diode 2 channel
to trigger the Critical / Thermal Shutdown circuitry (see Section 5.1).
SMSC EMC2103
47
DATASHEET
Revision 0.85 (01-29-08)