USB2601_06 Datasheet, PDF (15/26 Pages) SMSC Corporation – 4th Generation USB2.0 Flash Media Controller with Integrated Card Power FETs and HS Hub

4th Generation USB2.0 Flash Media Controller with Integrated Card Power FETs and HS Hub
Datasheet
NAME
Over Current Sense
Green LED
CF Chip Select 1
CF Chip Select 0
CF Register
Address 2
CF Register
Address 1
CF Register
Address 0
CF Interrupt
CF
Data 15-8
CF
Data7-0
IO Ready
CF
Card Detection2
CF
Card Detection1
CF
Hardware Reset
SYMBOL
BUFFER
TYPE
DESCRIPTION
OCS[4:2]_N
IPU
Input from external current monitor indicating an over-
current condition. {Note: Contains internal pull-up to
3.3V supply}
GR[4:2]_N
I/O8
Green indicator LED for ports 2, 3 and 4. Will be active
low when LED support is enabled via EEPROM or
SMBus.
CompactFlash (In True IDE mode) INTERFACE
CF_nCS1
O8PU
This pin is the active low chip select 1 signal for the CF
ATA device
CF_nCS0
O8PU
This pin is the active low chip select 0 signal for the task
file registers of CF ATA device in the True IDE mode.
CF_SA2
O8
This pin is the register select address bit 2 for the CF
ATA device.
CF_SA1
O8
This pin is the register select address bit 1 for the CF
ATA device
CF_SA0
O8
This pin is the register select address bit 0 for the CF
ATA device.
CF_IRQ
IPD
This is the active high interrupt request signal from the
CF device.
CF_D[15:8]
I/O8PD
The bi-directional data signals CF_D15-CF_D8 in True
IDE mode data transfer.
In the True IDE Mode, all of task file register operation
occur on the CF_D[7:0], while the data transfer is on
CF_D[15:0].
The bi-directional data signal has an internal weak pull-
down resistor.
CF_D[7:0]
I/O8PD
The bi-directional data signals CF_D7-CF_D0 in the
True IDE mode data transfer.
In the True IDE Mode, all of task file register operation
occur on the CF_D[7:0], while the data transfer is on
CF_D[15:0].
The bi-directional data signal has an internal weak pull-
down resistor.
CF_IORDY
IPU
This pin is active high input signal.
This pin has an internally controlled weak pull-up
resistor.
CF_nCD2
IPU
This card detection pin is connected to the ground on
the CF device, when the CF device is inserted.
This pin has an internally controlled weak pull-up
resistor.
CF_nCD1
IPU
This card detection pin is connected to ground on the
CF device, when the CF device is inserted.
This pin has an internally controlled weak pull-up
resistor.
CF_nRESET
O8
This pin is an active low hardware reset signal to CF
device.
SMSC USB2601/USB2602
15
DATASHEET
Revision 1.5 (07-24-06)