HYC9088A Datasheet, PDF (11/13 Pages) SMSC Corporation – ARCNET TWISTED PAIR AND COAXIAL COMPLATIBLE HIGH IMPEDANCE TRANSCEIVER HIT

OPERATIONAL DESCRIPTION
MAXIMUM GUARANTEED RATINGS*
Operating Temperature Range.....................................................................................................0^oC to +70^oC
Storage Temperature Range ..................................................................................................... -55^o to +150^oC
Lead Temperature Range (soldering, 10 seconds) ...............................................................................+325^oC
Positive Voltage on any pin, with respect to Ground ...........................................................................V_cc+0.3V
Negative Voltage on any pin, except V_DD, with respect to Ground ........................................................... -0.3V
*Stresses above those listed above could cause permanent damage to the device. This is a stress rating
only and functional operation of the device at any other condition above those indicated in the operation
sections of this specification is not implied.
Note: When powering this device from laboratory or system power supplies, it is important that the
Absolute Maximum Ratings not be exceeded or device failure can result. Some power supplies exhibit
voltage spikes on their outputs when the AC power is switched on or off. In addition, voltage transients on
the AC power line may appear on the DC output. If this possibility exists, it is suggested that a clamp circuit
be used.
DC ELECTRICAL CHARACTERISTICS (TA = 0^oC to 70^oC, VCC2 = +5.0 V ± 5%, VDD = -5.0V ± 5%)
PARAMETER
SYMBOL MIN TYP MAX UNITS
COMMENTS
Low Input Voltage
V_IL
0.8
V I_IL = -0.8 mA
High Input Voltage
Received Signal Amplitude
Low Output Voltage
High Output Voltage
Transformer Output
Cable Noise Amplitude
V_CC Supply Current
V_IH
2.0
V I_IH = +0.2 mA
V_R
6.0
3.0
V_OL
V_p-p
V_o-p
0.4
V One TTL Load
V_OH
2.4
V One TTL Load
V_T
16
20
8
10
V_p-p Z_chr cable = 120Ω or
V_O-p 93Ω
V_C
4
V_p-p
I_CC
190 285
mA
V_DD Supply Current
I_DD
180 270
mA
Pulse Width, nPulse 1, n2
PW
100
nS
Shorting the transformer output may cause permanent damage to the device.
11