97CFDC Datasheet, PDF (11/20 Pages) SMSC Corporation – USB FLOPPY DISK CONTROLLER

DC PARAMETERS
MAXIMUM GUARANTEED RATINGS
Operating Temperature Range ...........................................................................................................................0^oC to +70^oC
Storage Temperature Range ........................................................................................................................... -55^o to +150^oC
Lead Temperature Range (soldering, 10 seconds).....................................................................................................+325^oC
Positive Voltage on any pin, with respect to Ground (Note 1)...................................................................................Vcc+0.3V
Negative Voltage on any pin, with respect to Ground .................................................................................................... -0.3V
Maximum Vcc .................................................................................................................................................................. +3.6V
Note 1: Maximum voltage on all I type Inputs and the IS inputs, OD12 and OD24 outputs for floppy disk drive interface is
5.25V
*Stresses above the specified parameters could cause permanent damage to the device. This is a stress rating only
and functional operation of the device at any other condition above those indicated in the operation sections of this
specification is not implied.
Note 2: When powering this device from laboratory or system power supplies, it is important that the Absolute Maximum
Ratings not be exceeded or device failure can result. Some power supplies exhibit voltage spikes on their outputs when
the AC power is switched on or off. In addition, voltage transients on the AC power line may appear on the DC output.
When this possibility exists, it is suggested that a clamp circuit be used.
DC ELECTRICAL CHARACTERISTICS (TA = 0°C - 70°C, Vcc = +3.3 V ± 10%)
PARAMETER
SYMBOL MIN TYP MAX UNITS
COMMENTS
I Type Input Buffer
Low Input Level
VILI
0.8
V TTL Levels
High Input Level
VIHI
2.0
V
ICLK Input Buffer
Low Input Level
VILCK
0.4
V
High Input Level
VIHCK
2.2
V
Input Leakage
(All I and IS buffers)
Low Input Leakage
IIL
-10
+10
uA VIN = 0
High Input Leakage
O8 Type Buffer
IIH
-10
+10
uA VIN = VCC
Low Output Level
VOL
0.4
V
IOL = 8 mA
High Output Level
VOH
2.4
V
IOH = -4 mA
Output Leakage
I/O8 Type Buffer
IOL
-10
+10
UA VIN = 0 to VCC (Note 1)
Low Output Level
VOL
0.4
V IOL = 8mA
High Output Level
VOH
2.4
V IOH = -4mA
Output Leakage
OD12 Type Buffer
IOL
-10
+10
µA VIN = 0 to Vcc (Note 1)
Low Output Level
VOL
0.4
V IOL = 12mA
Output Leakage
IOL
-10
+10
µA VIN = 0 to Vcc (Note 1)
SMSC DS – USB97CFDC
Page 11
Rev. 12/15/2000