DK-28210-M2-UL Datasheet, PDF (246/291 Pages) SL Power Electronics – CB TEST CERTIFICATE CERTIFICAT D’ESSAI OC

Issue Date: 2012-09-24
Page 39 of 41
Report Reference #
E300305-A33-CB-4
SubClause Difference + Test
IEC 60950-1:2005
Result - Remark
6.4
6.4
7
H
M.2
M.4
NAC
NAC
equipment to provide power over
telecommunication wiring system not
interchangeable with devices of higher ratings if
operator replaceable.
Additional requirements for equipment
intended for connection to a telecommunication
network using cable subject to overvoltage from
power line failures (Fig. 6C).
Where 26 AWG line cord required by Fig.
6C, either the cord is provided with the equipment
or described in the safety instructions.
Equipment associated with the cable
distribution system may need to be subjected to
applicable parts of Chapter 8 of the NEC.
Ionizing radiation measurements made
under single fault conditions in accordance with the
requirements of the Code of Federal Regulations
21 CFR 1020 and the Canadian Radiation Emitting
Devices Act, REDR C1370.
Continuous ringing signals evaluated to
Method A subjected to special accessibility
considerations.
Special requirements for message waiting
and similar telecommunications signals.
Equipment intended for use with a generic
secondary protector marked with suitable
instructions.
Equipment intended for use with a specific
Verdict
N/A
N/A
N/A
N/A
N/A
N/A
N/A
N/A
This report issued under the responsibility of UL