PENB1020B Datasheet, PDF (1/2 Pages) SL Power Electronics – Universal 15.4W Gigabit PoE Adapter

PENB1020B
Universal 15.4W
Gigabit PoE Adapter
3 Year Warranty
•10/100/1000 (MbPS) Data Rates
•Self-contained Injector
•100-240Vac Universal Input
•IEEE802.3af Compliant Detection, Disconnect,
Overload Control Function
•Load Diagnostic LED
•Overload Shutdown and Short Circuit Protection
•Regulated Output with Low Ripple
•Compliant to UL/IEC/EN60950-1
•LPS (Limited Power Source) Compliant
Description
The PENB1020B Series of Power-over-Ethernet (PoE) adapters operate from a 90 to 264Vac input
range, and provide up to 15.4W of output power at an output voltage of 48Vdc. These models are
capable of operating with Gigabit Data rates, and are IEEE802.3af compliant. Features include
diagnostic LED, and overvoltage, overload, and short circuit protection.
Specifications
AC Input
All specifications are typical at nominal input, full load at 25°C unless otherwise stated
100-240Vac +/- 10%, 47-63 Hz single phase MTBF
>60,000 hours, calculated (7 years)
Input Current
Input Inrush Current
0.5A @ 90Vac
0.25A @ 180Vac
60A peak, cold start
Hold-Up Time
Efficiency
16mS min. @ 110Vac, 60Hz
65% minimum
Input Protection
Internal Primary Current Fuse provided,
250Vac/3.15A
Dialectric Withstand
4242Vdc Primary – Secondary,
2,150Vdc Primary–GND, 500Vdc Secondary - GND
Earth Leakage Current
<250µA @ 264Vac, 60Hz
Output Power
15.4W continuous, convection cooled
Ripple and Noise
Per (IEEE 802.3af 33.2.8.3)
f < 500Hz: 500mVp-p; 500Hz to 150kHz: 200mVp-p
150kHz to 500kHz: 150mVp-p; 500kHz to 1MHz: 100mVp-p
Output Voltage (Vport)¹
+48Vdc Typical, 44V to 57V
(IEEE 802.3af 33.2.8.1)
Output Inrush Current (Iinrush)
450mA max.
Output current in startup mode. (IEEE 802.3af 33.3.8.5)
Overload Current Detection (Icut)
400mA max.
(IEEE 802.3af 33.3.8.6)
Short Circuit Protection (Ilim)
400 to 450mA max.
Output current - at short circuit limit. (IEEE 802.3af 33.3.8.8)
Overload time limit (Tovld)
50 to 75ms
(IEEE 802.3af 33.3.8.7)
Short circuit time limit (Tlim)
50 to 75ms
(IEEE 802.3af 33.3.8.9)
Operating Temperature
0° to +40°C
Transient Response
0.5msec for 50% load change typical
Storage Temperature
-30° to +85°C
Regulation
See chart below Relative Humidity
5% to 95%, non-condensing
Case Material
94V-0 Black Polycarbonate Altitude
0 to 10,000 ft
Dimensions
W: 1.9” x L: 4.44” x H: 1.3”. Weight: 120g Safety Standards
UL/IEC/EN60950-1, CE, CB
Note: 1. The voltage potential shall be measured between any conductor of one power pair and any conductor of the other power pair
Models
Model
Output Output
Ripple
Max. _Regulation IEEE802.3af AC Input
Number
Voltage Current¹ & Noise² ^Power Line Load³ ^{Compliant? Receptacle}
PENB1020B4800F01
PENB1020B4800N01
48Vdc
48Vdc
0.35A
0.35A
See table
above
15.4W
15.4W
±1%
±1%
±4%
±4%
Yes
IEC60320, C14
Yes
IEC60320, C8
Note: 1. (Iport): Maximum output current in normal powering mode at PSE min output voltage. (IEEE 802.3af 33.3.8.4)
2. Measured at 20MHz bandwidth, with noise probe as close to output RJ-45 connector as possible, and load terminated with 0.1μF
ceramic and 10μF low ESR electrolytic capacitors.
3. per (IEEE 802.3af 33.2.8.2)
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone [phone] • Fax [phone] • Email: [e-mail] • www.slpower.com