PENB1020A Datasheet, PDF (1/2 Pages) SL Power Electronics – Universal 19.2W Gigabit PoE Adapter

PENB1020A
Universal 19.2W
Gigabit PoE Adapter
•10/100/1000 (MbPS) Data Rates
•Self-contained Injector
•100-240Vac Universal Input
•Green DC Power LED
•Overload and Short Circuit Protection
•Regulated Output with Low Ripple
•Compliant to UL/IEC/EN60950-1
•LPS (Limited Power Source) Compliant
•RoHS Compliant
3 Year Warranty
Description
The PENB1020A Series of Power-over-Ethernet (PoE) adapters operate from a 90 to 264Vac input
range, and provide up to 19.2W of output power at an output voltage of 48Vdc. These models are
capable of operating with Gigabit Data rates, and include features include diagnostic LED, and
overvoltage, overload, and short circuit protection. This non-compliant adapter does not require a
“handshake” signal to enable the output voltage.
Specifications
AC Input
All specifications are typical at nominal input, full load at 25°C unless otherwise stated
100-240Vac +/- 10%, 47-63 Hz single phase MTBF
>60,000 hours, calculated (7 years)
Input Current
Input Inrush Current
0.5A @ 90Vac
0.25A @ 180Vac
60A peak, cold start
Hold-Up Time
Efficiency
18mS min. @ 115Vac, 60Hz
60mS min. @ 230Vac, 60Hz
65% minimum
Input Protection
Internal Primary Current Fuse provided,
250Vac/3.15A
Dialectric Withstand
4242Vdc Primary – Secondary,
2,150Vdc Primary–GND, 500Vdc Secondary - GND
Earth Leakage Current
<250µA @ 264Vac, 60Hz
Turn-on Time
Rise Time
Short Circuit Protection
2.0 seconds max., at 115v230Vac, 60Hz
100mS max.@ 115/230Vac, 60Hz
10 minutes max. @ 265Vac, 60Hz
Output Power
Ripple and Noise
19.2W continuous, convection cooled Operating Temperature
See Chart below Storage Temperature
0° to +40°C
-30° to +85°C
Output Voltage
48Vdc Typical Relative Humidity
5% to 95%, non-condensing
Transient Response
Regulation
0.5msec for 50% load change typical
Altitude
See chart below Safety Standards
0 to 10,000 ft
UL/IEC/EN60950-1, CE, CB
Case Material
94V-0 Black Polycarbonate Dimensions
W: 1.9” x L: 4.44” x H: 1.3”. Weight: 120g
Models
Model
Number
PENB1020A4800F01
Output
Voltage
48Vdc
Output
Current
0.4A
Ripple
& Noise¹
480mV pk-pk
Max.
Power
15.4W
Regulation ^IEEE802.3af
Line Load ^Compliant?
±2% ±5%
No
PENB1020A4800N01 48Vdc
0.4A 480mV pk-pk 15.4W ±2% ±5%
No
Note: 1. Measured at 20MHz bandwidth, with noise probe as close to output RJ-45 connector as possible, and load terminated with 0.1μF
ceramic and 10μF low ESR electrolytic capacitors.
AC Input
Receptacle
IEC60320, C14
IEC60320, C8
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone [phone] • Fax [phone] • Email: [e-mail] • www.slpower.com