MENB1150 Datasheet, PDF (1/2 Pages) SL Power Electronics – Medical Switch-Mode Power Supply

MENB1150
Universal Input 150 Watt Series
Medical Switch-Mode Power Supply
•90-264VAC Universal Input
•Meets Efficiency Level V, EU (EC) No 278/2009 Phase II
•Meets UL/EN/IEC60601-1, 3^rd Edition, 2xMOPP
•Desktop Style
•12V to 24V Single Output Models, up to 150W
•Modified and Custom Designs Available
•Regulated Output with Low Ripple
•Impact-Resistant Polycarbonate Enclosure
•No Load Power Consumption <0.5W
International Safety Agency Approvals
3 Year Warranty
RoHS
Specifications
All Specifications are typical at nominal input, full load at 25C unless otherwise stated.
AC Input
Input Current
Inrush Current
100-240Vac, +/-10%, 47-63 Hz, 1
100 Vac: 2.5 A
60A peak @ 264Vac, cold start
MTBF
Hold-up Time
Turn-on Time
100,000 hours calculated
18 mS min @ 110Vac, 21mS min @ 240 Vac
2 sec max @110/240Vac
Input Fuse
3.15A, 250V Internal Primary Current Fuse provided Output Rise Time
200mS max @ 11//240Vac
Efficiency
Output Voltage
Output Power
Ripple and Noise
Line/Load Regulation
Transient Response
Minimum Load
Case Material
Meets Efficiency Level V, ErPII
See chart
See chart
1% pk-pk max., 20MHz BW
Excluding Cord: Line: +/- 1%, Load: +/-5%
500μs max., 50% load step, typical
Not required
Black 94V0 Polycarbonate
Overload Protection
Hiccup Mode
Short Circuit Protection
Hiccup Mode
Topology
Switching – Fixed Frequency Flyback
Safety and EMC Approvals
EN/IEC/CSA/UL60601-1, 3^rd Edition
EMC: See chart
Dielectric Withstand
Input-Output: 2 x MOPP
Input-GND:1 x MOPP, Output-GND: 500Vdc
Operating Temperature
0 to 40C, no derating
Storage Temperature
-30 to +85C
Relative Humidity
5% to 95%, non-condensing
Case Dimensions
Weight
212mm x 67mm x 48mm, see mechanical drawing
700g
Altitude
0 to 10,000 ft
Output Connections
Cable: 18AWG UL2464, 1200mm, 4 conductor
Connector: Ault #51, 6-pin Molex, other options available
Conducted Emissions
Radiated Emissions
Line Frequency Harmonics
Voltage Fluctuations
Static Discharge Immunity
Radiated RF Immunity
EFT/Burst Immunity
Line Surge Immunity
Conducted RF Immunity
Power Frequency Magnetic Field Immunity
Voltage Dip Immunity
EMI/EMC Compliance
EN55011/22, Class B
EN55011/22, Class B
EN61000-3-2
EN61000-3-3, Line Flicker
EN61000-4-2, 6kV Contact Discharge, 8kV air discharge, Criteria A
EN61000-4-3, 3V/m, Criteria A
EN61000-4-4, 2kV/5kHz, Criteria A
EN61000-4-5, 1kV diff., 2kV common-mode, Criteria A
EN61000-4-6, 3Vrms, Criteria A
EN61000-4-8, 3A/m, Criteria A
EN61000-4-11, 100% dip, 10mS, Crit. A; 60% dip, 100mS, Crit. A; 30%
dip, 500mS, Crit. C; 100%, 5000mS, Crit. C.
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp  6050 King Drive Ventura, CA 93003  Phone [phone]  Fax [phone]  Email: [e-mail]  www.slpower.com