CENB1050 Datasheet, PDF (1/2 Pages) SL Power Electronics – I.T.E. Switch-Mode Power Supply

CENB1050
Universal Input 50 Watt Series
I.T.E. Switch-Mode Power Supply
•100-240Vac Universal Input
•Meets EISA2007, CEC Efficiency Level V,
EU (EC) No 278/2009 Phase II
•Certified to UL/EN60950-1 2^nd Edition, LPS
•Desktop Style
•5V to 48V Single Output Models, up to 50W
•Modified and Custom Designs Available
•Regulated Output with Low Ripple
•Impact-Resistant Polycarbonate Enclosure
•No load Power Consumption <0.3W
3 Year Warranty
RoHS LPS
Specifications
All Specifications are typical at nominal input, full load at 25°C unless otherwise stated.
AC Input
100-240Vac, -/-10%, 47-63 Hz, 1∅ MTBF
>100,000 hours (calculated)
Input Current
100VAC: 1.5A max Hold-up Time
18 ms min. @ 115Vac, 60 ms min. @ 230 Vac
Inrush Current
60 A peak, 264 V, cold start Overload Protection
Hiccup Mode
Input Fuse
2.0A, 250V Internal Primary Current Fuse is provided Short Circuit Protection
Hiccup Mode
Efficiency
Output Voltage
Output Power
EISA2007, CEC Efficiency Level V,
EU (EC) No 278/2009 Phase II
See chart
Topology
Safety Standards
See chart EMC
Switching – Fixed Frequency Flyback
EN/IEC/CSA/UL60950-1, 2nd Edition
LPS (9V thru 48V models)
See chart below
Ripple and Noise
Line & Load Voltage Regulation
1% pk-pk max., 20MHz BW Dielectric Withstand
Line: +/- 1%, Load: +/-5% Operating Temperature
Input-Output: 4,242 Vdc,
Input-GND: 1,500 Vac, Output-GND: 500Vdc
0° to 40°C, no derating
Transient Response
500µs max., 50% load step, typical Storage Temperature
-30 to +85°C
Minimum Load
Not required Relative Humidity
5% to 95%, non-condensing
Case Material
Black 94V0 Polycarbonate Altitude
0 to 10,000 ft
Case Dimensions
Weight
See outline drawing
400g
Output Cable 5V – 9V models: #18AWG (UL2464), 1,200mm, 4 conductor
12V – 15V models: #18AWG (UL2464), 1,500mm, 4 conductor
18V – 48V models: #18AWG (UL2464), 1,500mm, 2 conductor
Output Connector 2.5mm barrel type (Ault #3), center contact positive (+)
Conducted Emissions
Radiated Emissions
Line Frequency Harmonics
Voltage Fluctuations/Flicker
Static Discharge Immunity
Radiated RF Immunity
EFT/Burst Immunity
Line Surge Immunity
Conducted RF Immunity
Power Frequency Magnetic Field Immunity
Voltage Dip Immunity
EMC Specifications
EN55022 Class B, FCC Part 15, Class B.
EN55022 Class B, FCC Part 15, Class B.
EN61000-3-2, Class A
EN61000-3-3
EN61000-4-2, 6kV Contact Discharge, 8kV air discharge
EN61000-4-3, 3V/m.
EN61000-4-4, 2kV/5kHz.
EN61000-4-5, 1kV differential, 2kV common-mode
EN61000-4-6, 3Vrms
EN61000-4-8, 3A/m
EN61000-4-11, Criteria B
______________________________________________________________________________________________________________________________ 1 of 2
SL Power Electronics Corp • 6050 King Drive Ventura, CA 93003 • Phone [phone] • Fax [phone] • Email: [e-mail] • www.slpower.com