SKY13322-375LF_10 Datasheet, PDF (5/9 Pages) Skyworks Solutions Inc. – 0.1-6.0 GHz GaAs SP4T Switch

DATA SHEET • SKY13322-375LF SP4T SWITCH
Table 5. SKY13322-375LF Truth Table
V1 (Pin 4) V2 (Pin 2) V3 (Pin 7) V4 (Pin 9)
RFC to J1
RFC to J2
RFC to J3
RFC to J4
1
0
0
0
Insertion loss
Isolation
Isolation
Isolation
0
1
0
0
Isolation
Insertion loss
Isolation
Isolation
0
0
1
0
Isolation
Isolation
Insertion loss
Isolation
0
0
0
1
Isolation
Isolation
Isolation
Insertion loss
Note: “1” = +1.8 V to +5 V. “0” = 0 V to +0.2 V. Any state other than described in this Table places the switch into an undefined state. An undefined state will not damage the device.
Evaluation Board Description
The SKY13322-375LF Evaluation Board is used to test the
performance of the SKY13322-375LF SPDT Switch. An Evaluation
Board schematic diagram is provided in Figure 9. An assembly
drawing for the Evaluation Board is shown in Figure 10.
Package Dimensions
The PCB layout footprint for the SKY13322-375LF is provided in
Figure 11. Typical case markings are shown in Figure 12.
Package dimensions for the 10-pin MLPD are shown in Figure 13,
and tape and reel dimensions are provided in Figure 14.
Package and Handling Information
Since the device package is sensitive to moisture absorption, it is
baked and vacuum packed before shipping. Instructions on the
shipping container label regarding exposure to moisture after the
container seal is broken must be followed. Otherwise, problems
related to moisture absorption may occur when the part is
subjected to high temperature during solder assembly.
THE SKY13322-375LF is rated to Moisture Sensitivity Level 1
(MSL1) at 260 C. It can be used for lead or lead-free soldering.
Care must be taken when attaching this product, whether it is
done manually or in a production solder reflow environment.
Production quantities of this product are shipped in a standard
tape and reel format.
RF Output
DC Control
Voltage (1.8-5.0 V)
DC Control
Voltage (1.8-5.0 V)
RF Output
C_{BL 1}
J2
2
V2
3
× _N/C
4
V1
C_{BL 5}
J1
10
C_BL
J4
9
V4
8
C_BL
RFC
7
V3
6
C_BL
J3
RF Output
DC Control
Voltage (1.8-5.0 V)
RF Common
Input
DC Control
Voltage (1.8-5.0 V)
RF Output
C_BL = 47 pF for >1 GHz operation.
Exposed ground paddle should be grounded
for best performance.
Use 10 nF blocking capacitors (C_BL) for <50 MHz operation.
S1551
Figure 9. SKY13322-375LF Evaluation Board Schematic
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
201098C • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice • August 4, 2010
5