SKY65016-70LF Datasheet, PDF (3/5 Pages) Skyworks Solutions Inc. – InGaP Cascadable Amplifier LF-3 GHz

DATA SHEET • SKY65016-70LF
Absolute Maximum Ratings
Characteristic
Value
RF input power
15 dBm
Supply voltage
5V
Supply current
120 mA
Power dissipation @ T = 25 °C
500 mW
Operating temperature
-40 °C to +85 °C
Storage temperature
-65 °C to +125 °C
Performance is guaranteed only under the conditions listed in the specifications table and is
not guaranteed under the full range(s) described by the Absolute Maximum specifications.
Exceeding any of the absolute maximum/minimum specifications may result in permanent
damage to the device and will void the warranty.
CAUTION: Although this device is designed to be as robust as
possible, Electrostatic Discharge (ESD) can damage
this device. This device must be protected at all times
from ESD. Static charges may easily produce poten-
tials of several kilovolts on the human body or
equipment, which can discharge without detection.
Industry-standard ESD precautions must be employed
at all times.
SOT-89
7°
1.50
0.381 ± 0.025
R0.10
Sharp
R0.10
0.46
Side View
Half Etching
Depth 0.100
7°
1.50 ± 0.10
End View
3
2
1
Bottom View
All measurements are in millimeters
Pin Out (Top View)
4
1
2
3
Pin Descriptions
Pin Number
2, 4
Pin Name
GND
1
Input
3
Output
Description
Equipotential point – Internal circuit com-
mon, which must be connected to the PCB
ground or common via the lowest possible
impedance. Pin 4 must be connected via a
low thermal resistance path to a good
heatsink.
RF input – RF input with 50 Ω nominal
input impedance. An internally generated
DC voltage is present at this pin, so an
external DC block should be used to
connect this pin to the external circuit.
RF output – DC supply voltage input and
RF output with 50 Ω nominal output
impedance. The nominal voltage required
at this pin is listed in the Electrical
Specifications Table. Supply current is
determined by an external resistor
connected between the DC power supply
and this pin.
Recommended Solder Reflow Profiles
Refer to the “Recommended Solder Reflow Profile”
Application Note.
Tape and Reel Information
Refer to the “Discrete Devices and IC Switch/Attenuators
Tape and Reel Package Orientation” Application Note.
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
200357 Rev. C • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice. • September 25, 2006
3