RFX8053 Datasheet, PDF (3/6 Pages) Skyworks Solutions Inc. – Low Noise Amplifier with Bypass Mode

RFX8053
Advanced Data Sheet
ABSOLUTE MAXIMUM RATINGS:
Parameters
DC VDD Voltage Supply
DC Control Pin Voltage
DC VDD Current
Consumption
TX RF Input Power
ANT RF Input Power
Junction Temperature
Storage Ambient
Temperature
Operating Temperature
ESD (HBM)
Units
V
V
mA
dBm
dBm
o_C
o_C
o_C
V
Min
0
0
-40
-40
1000
Max
5.5
3.6
400
+7
+10
150
+150
+85
Conditions
All VDD Pins
All Control Pins
Through VDD Pins when TX is “ON”
Bypass Mode
Appropriate care required according
to JEDEC Standards
Case Temperature
Note: Sustained operation at or above the Absolute Maximum Ratings for any one or combinations of the above
parameters may result in permanent damage to the device and is not recommended.
All Maximum RF Input Power Ratings assume 50-Ohm terminal impedance.
NOMINAL OPERATING CONDITIONS:
Parameters
DC VDD Voltage Supply (Note 1)
Control Voltage “High” (Note 2)
Control Voltage “Low”
DC Control Pin Current
Consumption
DC Shutdown Current
PA Turn On/Off Time
jc (Note 3)
ja
Antenna Switch Speed
Units Min
V
3.0
V
1.2
V
0
μA
μA
μsec
o_C/W
o_C/W
μsec
Typ Max
3.6
4.8
*
0.3
1
3
10
0.4
28
44
0.4
Conditions
All VDD Pins
* 3.6V or VDD Whichever is Lower
Note 1: For normal operation of the RFX8053, VDD must be continuously applied to all VDD supply pins.
Note 2: If control voltage can exceed 1.8V, a 1KΩ – 10KΩ series resistor is recommended for the application
circuit on each control line.
Note 3: Thermal measurements were performed on an RFaxis test EVB under typical use conditions. Please
contact RFaxis for details regarding the test conditions and the configuration of the thermal vias on the
EVB. Refer to “PCB Land Pattern” for recommended thermal vias.
3
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com