RFX2402E Datasheet, PDF (3/7 Pages) Skyworks Solutions Inc. – CMOS 2.4GHZ TRANSMIT/RECEIVE WLAN RFeIC

RFX2402E
Production Data Sheet
ABSOLUTE MAXIMUM RATINGS:
Parameters
DC VDD Voltage Supply
DC Control Pin Voltage
Units
Min
V
0
V
0
DC VDD Current Consumption
mA
DC Control Pin Current
Consumption
TX RF Input Power
ANT RF Input Power
Junction Temperature
μA
dBm
dBm
o_C
Storage Ambient Temperature
o_C
-50
Max
4.5
3.6
350
1
+10
+5
+150
+150
Conditions
All VDD Pins
Through 1Kohm resistor
Through VDD Pins when TX is “ON”
All Operating Modes
When RX is “ON”
No RF and DC Voltages Applied
Appropriate care required according to
JEDEC Standards
Note: Sustained operation at or above the Absolute Maximum Ratings for any one or combinations of the above parameters may
result in permanent damage to the device and is not recommended. All Maximum RF Input Power Ratings assume 50-Ohm terminal
impedance.
NOMINAL OPERATING CONDITIONS:
Parameters
DC VDD Voltage Supply
Control Voltage “High” (Note 1)
Control Voltage “Low”
DC Control Pin Current Consumption
DC Shutdown Current
PA Turn On/Off Time
LNA Turn On/Off Time
Shut-Down and “ON” State Switching Time
Operating Ambient Temperature
ja
Units
V
V
V
uA
uA
usec
usec
usec
o_C
o_C/W
Min Typ Max
2.7 3.3
3.6
1.2
0.3
1
2
0.5
0.8
0.5
-40
+125
35
Conditions
All VDD Pins
Through Series Resistor
All Control Lines “Low”
See note 2
Note 1: If control voltage can exceed 1.8V, a 1KΩ – 10KΩ series resistor is recommended for the application
circuit on each control line.
Note2: For operation above +85 ^oC, use the ja as guidance for system design to assure the junction
temperature will not exceed the maximum of +150 ^oC.
3
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com