SKY65004 Datasheet, PDF (2/14 Pages) Skyworks Solutions Inc. – 250 -2700 MHz Linear Power Amplifier Driver

DATA SHEET • SKY65004 LINEAR PA DRIVER
Electrical and Mechanical Specifications
Signal pin assignments and functional pin descriptions are
provided in Table 1. The absolute maximum ratings of the
SKY65004 are provided in Table 2 and the recommended
operating conditions provided in Table 3. Electrical characteristics
of the SKY65004 are provided in Table 4.
The typical performance of the SKY65004 is illustrated in Figures
3 through 13. Package dimensions for the 4-pin SOT-89 option
are provided in Figure 17, and tape and reel dimensions are
shown in Figure 18. Package dimensions for the 3-pin MCM
option are shown in Figure 19, and tape and reel dimensions are
shown in Figure 20.
Package and Handling Information
Since the device package is sensitive to moisture absorption, it is
baked and vacuum packed before shipping. Instructions on the
shipping container label regarding exposure to moisture after the
container seal is broken must be followed. Otherwise, problems
related to moisture absorption may occur when the part is
subjected to high temperature during solder assembly.
The SKY65004 PA driver is available in two different package
options based on package type. The –21 MCM option is a Pb-free
package rated to Moisture Sensitivity Level 3 (MSL3) at 250 °C. It
can be used for lead or lead-free soldering
If the part is attached in a reflow oven, the temperature ramp rate
should not exceed 5 °C per second. Maximum temperature
should not exceed 225 °C and the time spent at a temperature
that exceeds 210 °C should be limited to less than 10 seconds. If
the part is manually attached, precaution should be taken to
ensure that the part is not subjected to a temperature that
exceeds 300 °C for more than 10 seconds.
For details on both attachment techniques, precautions, and
handling procedures recommended by Skyworks, please refer to
Skyworks Application Note, PCB Design and SMT
Assembly/Rework Guidelines for MCM-L Packages, document
number 101752. Additional information on standard SMT reflow
profiles can also be found in the JEDEC Standard J-STD-020.
Production quantities of both package types for this product are
shipped in standard tape and reel formats. For packaging details,
refer to the Skyworks Application Note, Tape and Reel, document
number 101568.
Electrostatic Discharge (ESD) Sensitivity
The SKY65004 is a static-sensitive electronic device. Do not
operate or store near strong electrostatic fields. Take proper ESD
precautions.
Table 1. SKY65004 Signal Descriptions
Pin #
1
RF_IN
2
GND
3
RF_OUT
4
GND
(SOT-89 package only)
Name
RF input
Ground
RF output
Ground
Description
Table 2. SKY65004 Absolute Maximum Ratings
(TA = +25 °C, unless otherwise noted)
Parameter
Symbol
Min
Typical
Max
Units
Supply voltage
VCC
6
V
RF output power
POUT
27
dBm
Supply current
ICC
160
mA
Power dissipation
PD
1.2
W
Operating case temperature
TC
–40
+85
°C
Storage temperature
TST
–55
+125
°C
Junction temperature
TJ
150
°C
Note: Exposure to maximum rating conditions for extended periods may reduce device reliability. There is no damage to device with only one parameter set at the limit and all other
parameters set at or below their nominal values.
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
2
September 25, 2006 • Skyworks Proprietary and Confidential information • Products and Product Information are Subject to Change Without Notice • 103155F