JC-BW140625-2 Datasheet, PDF (2/3 Pages) SHIKE Electronics – Tin Fung Road, Science City, Guangzhou High-tech Development Zone

Test Report
Report No.: JC-BW140625-2
Test Result
No.
Test Item
CAS No.
EC No.
1 Cadmium chloride^#
10108-64-2 233-296-7
2 Sodium peroxometaborate^#
7632-04-4 231-556-4
3 Sodium perborate; perboric acid,
sodium salt^#
——
239-172-9,
24-390-0
4 1,2-Benzenedicarboxylic acid, dihexyl ester,
68515-50-4 271-093-5
branched and linear
Component No.
& Test Result
(%,w/w)
1/2^*
N.D.
N.D.
N.D.
N.D.
MDL
(%,w/w)
0.01
0.01
0.05
0.01
Tested by: Dengpeng, Xishijin Checked by: Zhouxiaoyun, Jiangnengqiang
Test Component Description:
1. Silver color metal
2. Black plastic
Remark:
(1) N.D. = not detected, less than MDL
(2) MDL = method detection limit
(3) %, w/w = percentage of weight by weight
(4) *
(5) #
= As per the applicant's request, the mixed test was conducted.
= The substances are calculated by the test results of element (e.g. Co,As,Cr⁶⁺,Pb,Al,Zr,Mo,B) respectively,
identity of above metal substances present in the article has to be further confirmed.
(6) The chemical analysis of SVHC is performed by means of currently available analytical techniques against the list published
by ECHA. The list is under evaluation by ECHA and may subject to change in the future. Please refer to
http://echa.europa.eu/candidate-list-table
(7) In accordance with Regulation (EC) No 1907/2006,any producer or importer of articles shall notify ECHA, in accordance with
paragraph 4 of Article 7, if a substance meets the criteria in Article 57 and is identified in accordance with Article 59 (1) of the
Regulation, if (a) the substance is present in those articles in quantities totaling over one tonne per producer or importer per
year; and (b) the substance is present in those articles above a concentration of 0.1% weight by weight (w/w).
(8) Article 33 of Regulation (EC) No 1907/2006 requires supplier of an article containing a substance meeting the criteria in
Article 57 and identified in accordance with Article 59 (1) in a concentration above 0.1% weight by weight (w/w) shall
provide the recipient of the article with sufficient information, available to the supplier, to allow safe use of the article
including, as a minimum, the name of that substance.
(9) _{If a SVHC is found over the reporting limit, applicant is suggested to identify the component which contains the SVHC and}
the exact concentration of the SVHC by requesting further quantitative analysis from the laboratory.
(10) _{Test results in this report are based on the tested sample. This report refers to testing result of tested sample submitted as}
homogenous material(s). In case such material is being used to compose an article, the results indicated in this report may not
represent SVHC concentration in such article. If this report refers to testing result of composite material group by equal weight
proportion, the material in each composite test group may come from more than one article.
Attention: Please note that every statement made in this report is only valid for the samples tested and reported herein.
This report shall not be reproduced except in full, without the written approval of SKYTE.
Page 2 of 3