ST7687A Datasheet, PDF (62/191 Pages) Sitronix Technology Co., Ltd. – 128RGB x 128 dot 65K Color with Frame Memory Single-Chip CSTN Controller/Driver

ST7687A
8.1.2 SWRESET: Software Reset (01h)
Command
A0 /RD /WR D7 D6 D5 D4 D3 D2 D1 D0
SWRESET
01000000001
Hex
(01h)
Description
Restriction
Register
Availability
Default
When the Software Reset command is written, it causes a software reset. It
resets the commands and parameters to their S/W Reset default values and all
segment & common outputs are set to Vm (display off: blank display). (See
default tables in each command description)
Note: The Frame Memory contents are not affected by this command.
It will be necessary to wait 5msec before sending new command following
software reset. The display module loads all display suppliers’ factory default
values to the registers during 5msec. If Software Reset is applied during Sleep
Out mode, it will be necessary to wait 120msec before sending Sleep Out
command.
Software Reset command cannot be sent during Sleep Out sequence.
Status
Normal Mode On, Idle Mode Off, Sleep Out Yes
Normal Mode On, Idle Mode On, Sleep Out Yes
Partial Mode On, Idle Mode Off, Sleep Out Yes
Partial Mode On, Idle Mode On, Sleep Out Yes
Sleep In
Yes
Availability
Status
Power On Sequence
S/W Reset
H/W Reset
Default Value
N/A
N/A
N/A
Flow Chart
Ver. 1.0
62/191
2009/12