SP5301 Datasheet, PDF(6/13 Page) Sipex Corporation – Universal Serial Bus Transceiver

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

SP5301 Datasheet, PDF (6/13 Pages) Sipex Corporation – Universal Serial Bus Transceiver

◁

The SP5301 incorporates a receive error circuit.

This error circuit outputs CMOS signals on the

receive error pin (RERR) and the receive single

ended zero pin (RSE0) under specific conditions

from the USB bus. When OE is asserted LOW, it

enables the USB driver to transmit data on the D+

and D- output pins. The receive error circuit is

disabled in this condition and both RERR and

RSE0 are forced low. The receive error circuit is

activated in receive mode when OE is HIGH. The

receive error circuit will signal an error state

when both D+ and D- are HIGH by forcing RERR

HIGH. The receiver error circuit will signal a single

ended zero when both D+ and D- are LOW by

forcing RSE0 HIGH. A single ended zero is a

valid state and is used to signal an end of packet

(EOP) in signal transmission. (CAUTION: Since

both RERR and RSE0 are CMOS outputs, care

must be taken to ensure that RERR and RSE0

are NOT connected to VCC or GND.)

The SP5301 has a suspend input pin (SUSPND)

which enables a low power state while the USB

bus is inactive. When SUSPND is asserted HIGH

or SP5301 is in transmit mode (OE is LOW), the

receive data pin (RCV) will be forced LOW.

The SP5301 can transmit and receive serial data

at both full speed, 12Mbps, and at low speed,

1.5Mbps, data rates. At full speed, the active

supply current of the SP5301 is 6mA. In the

suspend state, the supply current is typically

20nA.

Full speed USB applications include ISDN,

PBX, POTS, sampled analog devices, audio,

printers, and telephony designs. Low speed USB

applications include locator devices, keyboards,

mouse, tablets, light pens, stylus, game

peripherals, virtual reality peripherals, and

monitor configurations. The USB protocol

provides full support for the real-time data

for voice, audio, and compressed video. The

SP5301 is specifically geared towards low-cost

USB solutions for the PC peripheral markets

Waveforms 1 and 2 below show device behavior

in transmit mode, at both low and full speed,

with the D+/D- pins driving the load specified

in figure 9.

[ T]

Ch1 500mV Ch2 500mV M 250nS Ch1 1.68 V

Waveform 1. D+/D- Transmit Mode, low speed

Ch1 500mV Ch2 500mV M 20.0nS Ch1 1.68 V

Waveform 2. D+/D- Transmit Mode, full speed

SP5301DS/10

SP5301 Universal Serial Bus Transceiver

▷