SP522 Datasheet, PDF (5/23 Pages) Sipex Corporation – Low-Cost Programmable Multi-Protocol Transceivers

ABSOLUTE MAXIMUM RATINGS
These are stress ratings only and functional operation
of the device at these ratings or any other above those
indicated in the operation sections of the specifications
below is not implied. Exposure to absolute maximum
rating conditions for extended periods of time may
affect reliability.
V_CC............................................................................+7V
V_DD........................................................................+12V
V_SS..........................................................................–12V
Input Voltages
Logic...............................-0.5V to (V_CC+0.5V)
Drivers............................-0.5V to (V_CC+0.5V)
Receivers..........................±30V@≤100mA
Outputs Voltages
Logic................................-0.5V to (V_CC+0.5V)
Drivers................................................+15V
Receivers........................-0.5V to (V_CC+0.5V)
Storage Temperature..........................-65˚C to +150˚C
Power Dissipation.........................................2000mW
OTHER AC CHARACTERISTICS
(Typical @ 25°C and nominal supply voltages unless otherwise noted)
PARAMETER
MIN. TYP. MAX.
UNITS
DRIVER DELAY TIME FROM ENABLE MODE TO TRI–STATE MODE
SINGLE–ENDED MODE (RS-232, RS-423)
t_PZL; Enable to Output low
600
ns
t_PZH; Enable to Output high
300
ns
t_PLZ; Disable from Output low
300
ns
t_PHZ; Disable from Output high
900
ns
DIFFERENTIAL MODE (RS-422, RS-485)
t_PZL; Enable to Output low
100
ns
t_PZH; Enable to Output high
120
ns
t_PLZ; Disable from Output low
100
ns
t_PHZ; Disable from Output high
160
ns
RECEIVER DELAY TIME FROM ENABLE MODE TO TRI–STATE MODE
SINGLE–ENDED MODE (RS-232, RS-423)
t_PZL; Enable to Output low
125
ns
t_PZH; Enable to Output high
120
ns
t_PLZ; Disable from Output low
90
ns
t_PHZ; Disable from Output high
90
ns
DIFFERENTIAL MODE (RS-422, RS-485)
t_PZL; Enable to Output low
125
ns
t_PZH; Enable to Output high
120
ns
t_PLZ; Disable from Output low
90
ns
t_PHZ; Disable from Output high
90
ns
CONDITIONS
3KΩ pull–up to output
3KΩ pull–down to output
5V to input
GND to input
C_L = 100pF, Fig. 4 & 6; S₁
closed
C_L = 100pF, Fig. 4 & 6; S₂
closed
C_L = 15pF, Fig. 4 & 6; S₁
closed
C_L = 15pF, Fig. 4 & 6; S₂
closed
3KΩ pull–up to output
3KΩ pull–down to output
5V to input
GND to input
C_RL = 15pF, Fig. 2 & 8; S₁
closed
C_RL = 15pF, Fig. 2 & 8; S₂
closed
C_RL = 15pF, Fig. 2 & 8; S₁
closed
C_RL = 15pF, Fig. 2 & 8; S₂
closed
Rev. 7/10/03
SP522 Multi–Mode Serial Transceivers
5
© Copyright 2003 Sipex Corporation