SPX1521_07 Datasheet, PDF (2/8 Pages) Sipex Corporation – 300mA Low Dropout Voltage Regulator

ABSOLUTE MAXIMUM RATINGS
Power Dissipation......................................................... Internally Limited
Lead Temp. (Soldering, 5 Seconds).............................................. 260°C
Storage Temperature Range......................................... -65°C to +150°C
Operating Junction Temperature Range ....................... -40°C to +125°C
Input Supply Voltage................................................... -20V to +20V
Shutdown Input Voltage...................................................-0.6V to +6.5V
ESD Rating................................................................................2kV Min
ELECTRICAL CHARACTERISTICS
Electrical characteristics at V_IN = 6V, I_O = 1mA, C_OUT = 2.2µF,T_A= 25°C, unless otherwise specified.
Boldface applies over the full operating temperature range.
PARAMETER

3.3V Version
Output Voltage
Reverse Output Current
5.0V Version
Output Voltage
Reverse Output Current
All Voltage Options
Output Voltage
Temperature Coefficient
Line Regulation
Load Regulation (Note 3)
CONDITIONS
(Note 2)
1mA ≤ I_L ≤ 300mA
V_OUT= 3.3V, V_IN= 0V
1mA ≤ I_L ≤ 300mA
V_OUT= 5.0V, V_IN= 0V
(Note1)
6V ≤ V_IN ≤ 20V (Note 4)
I_L=1 to 300mA
TYP
MIN
3.3
3.267
3.3
3.217
16
5.0
4.950
5.0
4.880
16
20
1.5
4
Dropout Voltage (Note 5)
I_L=1mA
0.13
I_L=300mA
0.30
Ground Current
I_L=1mA
100
I_L=10mA
350
I_L=50mA
1.5
I_L=100mA
2
I_L=300mA
5
Current Limit
V_OUT=0
330
Ripple Rejection
V_IN -V_OUT=1V(Avg),
58
50
V_RIPPLE=0.5Vp-p,
F_RIPPLE=120Hz, I_LOAD=150mA
Input Reverse Leakage Current V_IN= -20V, V_OUT=0V
MAX
3.333
3.382
25
5.050
5.120
25
100
20
20
30
0.17
0.25
0.55
0.70
150
500
3
6
14
500
1.0
UNITS
V
µA
V
µA
ppm/°C
mV
mV
V
µA
mA
mA
dB
mA
Note 1: Output or reference voltage temperature coefficients defined as the worst case voltage change divided
by the total temperature range.
Note 2: Unless otherwise specified all limits are guaranteed for T_j = 25°C, V_IN = 6V, I_L = 1mA and C_L = 2.2µF.
Note 3:Regulation is measured at constant junction temperature, using pulse testing with a low duty cycle.
Changes in output voltage due to heating effects are covered under the specification for thermal regulation.
Note 4:Line regulation for the SPX1521 is tested at 25°C for I_L = 1 mA. For T_J = 125°C, line regulation is
guaranteed by design.
Note 5: Dropout voltage is defined as the input to output differential at which the output voltage drops 100 mV
below its nominal value measured at 1V differential.
May15-07
SPX1521 300mA Low Dropout Voltage Regulator

© 2007 Sipex Corporation