SP6134HVLED Datasheet, PDF (2/4 Pages) Sipex Corporation – Evaluation Board Manual

USING THE EVALUATION BOARD
1) Powering Up the SP6134HVLED Circuit
The SP6134HVLED Evaluation Board can be powered from a 24V power supply. Connect with
short leads directly to the “VIN” and “GND” posts. Plug the 1W/3W/5W Luxeon LumiLED
between the “VOUT” and “VFB” posts. Refer to section 2 for Jumper (J1) setup for different
LumiLED applications.
2) Using the J1 Jumper for different LumiLED Applications
The SP6134HVLED Evaluation Board can be used to drive 1W, 3W or 5W LumiLED
respectively, this can be done by using the J1 Jumper. When no hat was used for the J1, it is
setup for 1W application. When the hat is put on 1 & 2 position, it is used for 5W application.
When the hat is put on 2 & 3 position, it is used for 3W application.
3) Selecting the Bias Resistor
The feedback voltage was programmed to be 200mV by using two divider resistors (R₂ and R₄)
at the soft start pin. (The internal 0.8V reference was overwritten by the programmed 0.2V to
reduce the sense voltage and increase the efficiency). The bias resistor is used to set the
operating current of the LumiLED as equation
R_b
=
V_FB
I_F
where V_FB is set as 200mV, I_F is the operating current of the LumiLED.
For 1W application, I_F=350mA, R_b=R₁=0.56Ohm
For 5W application, I_F=700mA, R_b=R₁//R₅=0.28Ohm
For 3W application, I_F=1000mA, R_b=R₁//R₃=0.2Ohm
POWER SUPPLY DATA
For the standard evaluation board, the following chart shows the efficiency data for different
applications.
100
95
90
85
1W
80
3W
5W
75
70
65
60
Single Two Three Four Five
Six
Fig. 1 Efficiency data of the SP6134HVLED evaluation board
2