SP490E Datasheet, PDF (2/12 Pages) Sipex Corporation – Enhanced Full Duplex RS-485 Transceivers

ABSOLUTE MAXIMUM RATINGS
These are stress ratings only and functional operation of the device at
these ratings or any other above those indicated in the operation sections
of the specifications below is not implied. Exposure to absolute maximum
rating conditions for extended periods of time may affect reliability.
V_CC....................................................................................................+7V
Input Voltages
Drivers................................................-0.5V to (V_CC+0.5V)
Receivers..................................................................±14V
Output Voltages
Drivers......................................................................±14V
Receivers...........................................-0.5V to (V +0.5V)
CC
Storage Temperature....................................................-65˚C to +150˚
Power Dissipation.....................................................................1000mW
SPECIFICATIONS
T_MIN to T_MAX and V_CC = 5V ± 5% unless otherwise noted.
PARAMETERS
MIN.
SP490E DRIVER
DC Characteristics
Differential Output Voltage
Differential Output Voltage
GND
2
Differential Output Voltage
1.5
Change in Magnitude of Driver
Differential Output Voltage for
Complimentary States
Driver Common-Mode
Output Voltage
Input High Voltage
2.0
Input Low Voltage
Input Current
Driver Short-Circuit Current
V_OUT = HIGH
V_OUT = LOW
SP490E DRIVER
AC Characteristics
Maximum Data Rate
10
Driver Input to Output
20
Driver Input to Output
20
Driver Skew
Driver Rise or Fall Time
3
TYP.
30
30
5
15
SP490E RECEIVER
DC Characteristics
Differential Input Threshold -0.2
Input Hysteresis
70
Output Voltage High
3.5
Output Voltage Low
Input Resistance
12
15
Input Current (A, B); V_IN = 12V
Input Current (A, B); V_IN = -7V
Short-Circuit Current
MAX. UNITS CONDITIONS
V_CC Volts
V_CC Volts
V_CC Volts
Unloaded; R = ∞; see Figure 1
With Load; R = 50Ω; (RS-422);
see Figure 1
With Load; R = 27Ω; (RS-485); see Figure 1
0.2 Volts
3 Volts
Volts
0.8 Volts
±10 µA
±250 mA
±250 mA
R = 27Ω or R = 50Ω; see Figure 1
R = 27Ω or R = 50Ω; see Figure 1
Applies to D
Applies to D
Applies to D
-7V ≤ V_O ≤ +12V
-7V ≤ V_O ≤ +12V
Mbps
60 ns
60 ns
ns
40 ns
R_DIFF = 54Ω, C_L1 = C_L2 = 100pF
t_PLH; R_DIFF = 54Ω, C_L1 = C_L2 = 100pF;
see Figures 3 and 6
t_PHL; R_DIFF = 54Ω, C_L1 = C_L2 = 100pF;
see Figures 3 and 5
see Figures 3 and 5,
t_SKEW = | t_DPLH - t_DPHL|
From 10% to 90%; R_DIFF = 54Ω,
C_L1 = C_L2 = 100pF; see Figures 3 and 5
+0.2 Volts
mV
Volts
0.4 Volts
kΩ
±1.0 mA
-0.8 mA
85 mA
-7V ≤ V_CM ≤ 12V
V_CM = 0V
I_O = -4mA, V_ID = +200mV
I_O = +4mA, V_ID = -200mV
-7V ≤ V_CM ≤ 12V
V_IN = 12V
V_IN = -7V
0V ≤ V_O ≤ V_CC
SP490EDS/14
SP490E Enhanced Full Duplex RS-485 Transceivers
2
© Copyright 2000 Sipex Corporation