SP333 Datasheet, PDF (2/13 Pages) Sipex Corporation – +5V Only RS-232/AppleTalk Programmable Transceiver

ABSOLUTE MAXIMUM RATINGS
These are stress ratings only and functional operation of the device at
these ratings or any other above those indicated in the operation sections
of the specifications below is not implied. Exposure to absolute maximum
rating conditions for extended periods of time may affect reliability.
V ...................................................................................................+12V
CC
Input Voltages
Logic........................................................-0.3V to (V_CC+0.5V)
Drivers..................................................-0.3V to (V_CC+0.5V)
Receivers..................................................................±15V
Driver Outputs......................................................................................±14V
Storage Temperature..................................................-65˚C to +150˚C
Power Dissipation..........................................................................1000mW
SPECIFICATIONS
T_MIN to T_MAX and V_CC = 5V±5% unless otherwise noted.
PARAMETER
MIN.
MAC Mode (pin 25 = +5V)
Differential Driver
High Level Output Voltage +3.6
Low Level Output Voltage
Differential Output, Load
Differential Output, No Load
Driver Short Circuit Current
Output Leakage Current
Input High Voltage
2.0
Input Low Voltage
Input Current
Transition Time
Propagation Delay
t_PHL
t_PLH
Data Rate
10
Single-Ended Inverting Driver
High Level Output Voltage +3.6
Low Level Output Voltage
–6.0
Driver Open Circuit Voltage
Driver Short Circuit Current
Input High Voltage
2.0
Input Low Voltage
Input Current
Transition Time
Propagation Delay
t_PHL
t_PLH
Data Rate
10
Differential Receiver
Differential Input Threshold -0.2
Input Hysteresis
Input Resistance
12
Output Voltage High
3.5
Output Voltage Low
Short Circuit Current
TYP. MAX. UNITS CONDITIONS
Volts
I_OH = 8mA
-3.6 Volts
I_OH = –8mA
±5V
Volts
R_L = 450Ω (TX outputs to GND)
±10 Volts
R_L = ∞
±40
500 mA
–7V≤V_O≤+7V; V_{IN LOW}≤0.8V or
V_{IN HIGH}≥2.0V
±100 µA
–7V≤V_O≤+7V; TxEN = V_CC
Volts
Applies to differential driver inputs
0.8
Volts
Applies to differential driver inputs
±20 µA
30
ns
V_IN = 0V to V_CC
R_L = 450Ω, C_L = 50pF; Rise/Fall
10% – 90%
100
ns
R_L = 450Ω, C_L = 50pF
100
ns
R_L = 450Ω, C_L = 50pF
Mbps
R_L = 450Ω, C_L = 50pF
+6.0 Volts
R_L = 450Ω to GND; V_{IN LOW}≤0.8V or
V_{IN HIGH}≥2.0V
–3.6 Volts
R_L = 450Ω to GND; V_{IN LOW}≤0.8V or
V_{IN HIGH}≥2.0V
±10 Volts
R_L = ∞
±40
mA
–7V≤V_O≤+7V; Infinite duration
Volts
Applies to single-ended driver inputs
0.8
Volts
Applies to single-ended driver inputs
±20 µA
30
ns
V_IN = 0V to V_CC
R_L = 450Ω, C_L = 50pF; Rise/Fall
10% – 90%
100
ns
R_L = 450Ω, C_L = 50pF
100
ns
R_L = 450Ω, C_L = 50pF
Mbps
R_L = 450Ω, C_L = 50pF
+0.2 Volts
-7V≤V_CM≤+7V
70
mV
V_CM=0V
kΩ
-7V≤V_CM≤+7V
Volts
I_SOURCE = –4mA
0.4
Volts
I_SINK = +4mA
85
mA
0V≤V_OUT≤V_CC
TGoddard/SP333/9617R0
SP333 RS-232/AppleTalk Programmable Transceiver
2
© Copyright 2000 Sipex Corporation