EZR-LEDK2W-434 Datasheet, PDF (9/14 Pages) Silicon Laboratories – Si4455 EZRADIO® TWO-WAY LINK DEMO KIT

Si4455-2WayLink-DEMO
Options:
PB1:
Stores new settings
Result: blinks all LED once
Next state: Ready state
2.4.1.6. Frequency Configuration Menu
The user can set the communication frequency in this menu state.
State Display:
LED2 blinks
Set the Configuration:
Set the frequency number on the switches by their frequency number:
Custom: SW1–SW4 are on
Freq. num. 1: SW1 is on, all others are off
Freq. num. 2: SW2 is on, all others are off
Freq. num. 3: SW3 is on, all others are off
Freq. num. 4: SW4 is on, all others are off
In case of wrong selection is set or the selected frequency number is not supported (e.g., no custom
frequency is stored) the default frequency of the used frequency band will be selected.
Options:
PB2:
Stores new settings
Results:
i. Blinks all LEDs once if selection is OK.
ii. Blinks LED4 and beeps buzzer once if the parameter had to be set to default because of an
unsupported selection.
Next State: Ready state
2.4.1.7. Data Rate Configuration Menu
The user can set the communication data rate in this menu state.
State Display:
LED3 blinks
Set the Configuration:
Set the data rate number on the switches by their frequency number:
Custom: SW1 – SW4 are on
Data rate num. 1: SW1 is on, all others are off
Data rate num. 2: SW2 is on, all others are off
Data rate num. 3: SW3 is on, all others are off
In case of wrong selection is set or the selected data rate number is not supported (e.g. no custom data
rate is stored) the default data rate will be selected.
Options:
PB3:
Stores new settings
Results:
i. blinks all LED once if selection is OK
ii. blinks LED4 and beeps buzzer once if parameter had to be set to default because of not
supported selection
Next state: Ready state
Rev. 0.1
9