SC91415CK Datasheet, PDF (14/23 Pages) Silan Microelectronics Joint-stock – TONE/PULSE SWITCHABLE DIALER WITH LCD INTERFACE AND DUAL-TONE MELODY

Silan
Semiconductors
SC91415 SERIES
I) LOCK function
The SC91415 series provide the LOCK function to inhibit toll dialing operation. Connecting a resistor on COL1 pin to
VSS can select different LOCK control method that is conventional key lock or password lock. Also the lock number
that can be selected by connecting the resistors on COL2 or COL3 pin. After power on reset, the password is fixed to
000 automatically. The lock function is disabled when the password is equal to 000.
How to setup password
* Set LOCK function to password control mode. (Connects a resistor on COL1 pin to VSS)
* Off hook (or turn on HF function)
* Push: # , # , ops1, ops2, ops3, nps1, nps2, nps3, # . If the ops1~ops3 are the same with current password, then
nps1~np3 will be stored in the dialer to replace current password. Otherwise, the current password can not be
updated. All the numbers pressed in the password setup procedure can not be dialed out when current password is
not equal to 000. If the current password are equal to 000, then only the first number “#” will be dialed out.
Normal dialing
Set lock function to none lock mode (without resistor connected to COL1 pin) or set password equal to 000. In this
case, the dialer is operated in normal mode and all functions work at unlimitation.
Dialing via LOCK function
Conventional key lock mode. (Connects a resistor on COL1 pin to VDD)
* Off hook (or turn on HF function)
* Keying: d1, d2, .. , dn . If the first number (d1) is the same with the lock number that optioned in table, then all entry
numbers can not be dialed out and keyboard will be inhibited until on to off hook once again. If the first number is not
equal to lock number, all the entry numbers will be dialed out.
Password control mode. (Connects a resistor on COL1 pin to VSS)
* Off hook (or turn on HF function)
* Keying: ( [#, ps1, ps2, ps3] + telephone number.) The numbers in the [ ] symbol could be omitted. The number “#”
will be inhibited when the current password is not equal to 000,and ps1, ps2, ps3 work at the checking state, not to
be dialed out. Other descriptions are as on following:
Incorrect password entry. The telephone numbers can not be dialed out.
Password is omitted. If the first digit of telephone numbers is the same with the lock number, all of the telephone
numbers can not be dialed out and keyboard will be inhibited until On to Off hook once again. If the first digit is not
equal to the lock number then the telephone numbers will be dialed out entirely.
Correct password entry. The telephone numbers can be dial out no matter what lock number is.
HANGZHOU SILAN MICROELECTRONICS JOINT-STOCK CO.,LTD
Rev: 2.0
2001-11-13
14