UG132 Datasheet, PDF (9/16 Pages) List of Unclassifed Manufacturers – CPT007B SLEXP8007A Kit

6. Connectors
UG132: CPT007B SLEXP8007A Kit User's Guide
Connectors
6.1 Breakout Pads
The "breakout pads" located on the left of the touch pads are routed to the capacitive sense input traces and power rails.
The capacitive sense input traces can be accessed through the vertically aligned vias located in middle of the board on the left of the
pads. All 7 CPT007B capacitive sensing touch pads are bound to each via.
Furthermore, above the buzzer, there are two breakout pads for VMCU and GND to measure the active current of the board using an
in-circuit ammeter. A 2.54 mm pitch pin header can be soldered in for easy access to these pins.
Note: In order for the capacitive sense pins to be connected properly to your application or power to be measured correctly, the 0 ohm
resistors must be removed. The 0 ohm resistor for a channel can be found next to the corresponding via on the top side of the board.
CS04
CS05
CS00
CS01
CS02
CS03
CS06
Figure 6.1. Breakout Pads
silabs.com | Smart. Connected. Energy-friendly.
Rev. 0.1 | 8