EFR32BG1B232 Datasheet, PDF (57/163 Pages) Silicon Laboratories – EFR32BG1 Blue Gecko Bluetooth® Smart SoC Family Data Sheet

EFR32BG1 Blue Gecko Bluetooth® Smart SoC Family Data Sheet
Electrical Specifications
4.1.10.6 Sub-GHz RF Receiver Characteristics in the 490 MHz Band
Unless otherwise indicated, typical conditions are: T_OP = 25 °C,VREGVDD = AVDD = IOVDD = 3.3 V, DVDD = RFVDD = PAVDD.
RFVDD and PAVDD path is filtered using ferrites. Crystal frequency=38.4MHz. RF center frequency 490 MHz. Test circuit according to
Figure 5.2 EFR32BG1 Typical Application Circuit: Configuration with DC-DC converter (PAVDD from VDCDC) on page 98 and Fig-
ure 5.5 Typical Sub-GHz RF impedance-matching network circuits on page 101. Unless otherwise indicated, all interferer tests have
been performed with an unmodulated (CW) interferer with the desired signal 3 dB above sensitivity limit.
Table 4.23. Sub-GHz RF Receiver Characteristics for 490 MHz Band
Parameter
Symbol
Test Condition
Min
Tuning frequency range
F_RANGE
470
Max usable input level, 0.1% SAT
BER
Desired is reference 2.4 kbps
—
GFSK signal¹
Desired is reference 38.4 kbps
—
GFSK signal²
Sensitivity
SENS
Desired is reference 2.4 kbps
—
GFSK signal¹, 0.1% BER
Desired is reference 38.4 kbps
—
GFSK signal², 0.1% BER
Desired is reference 10 kbps
—
GFSK signal³, 0.1% BER
Desired is reference 100 kbps
—
GFSK signal⁴, 0.1% BER
Level above which
RFSENSE_TRIG CW at 490 MHz
—
RFSENSE will trigger⁵
Level below which
RFSENSE_THRES
—
RFSENSE will not trigger⁵
Adjacent channel selectivity, C/I₁
Interferer is CW at ±1 ×
channel-spacing
Desired is 2.4 kbps GFSK signal¹
48
at 3dB above sensitivity level,
0.1% BER
Desired is 38.4kbps GFSK signal²
40
at 3dB above sensitivity level,
0.1% BER
Alternate channel selectivity, C/I₂
Interferer is CW at ±2 ×
channel-spacing
Desired is 2.4kbps GFSK signal¹
—
at 3dB above sensitivity level,
0.1% BER
Desired is 38.4kbps GFSK signal²
—
at 3dB above sensitivity level,
0.1% BER
Image rejection, Interferer is C/I_IMAGE
CW at image frequency
Desired is 2.4kbps GFSK signal¹
—
at 3dB above sensitivity level,
0.1% BER
Desired is 38.4kbps GFSK signal²
—
at 3dB above sensitivity level,
0.1% BER
Blocking selectivity, 0.1%
C/I_BLOCKER
Interferer CW at Desired ±1 MHz
—
BER. Desired is 2.4 kbps
GFSK signal¹ at 3 dB above
Interferer CW at Desired ±2 MHz
—
sensitivity level .
Interferer CW at Desired ±10 MHz
—
silabs.com | Building a more connected world.
Typ
—
—
—
-122.2
-111.7
-117.5
-107.6
-25.8
-50
58.4
Max
510
10
10
—
-108.9
-114.8
-104.7
—
—
—
Unit
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dBm
dB
47.5
—
dB
60.8
—
dB
51.7
—
dB
60.9
—
dB
53
—
dB
71.9
74.1
87.9
—
dB
—
dB
—
dB
Rev. 1.1 | 52