SI2456-FT Datasheet, PDF (35/74 Pages) Silicon Laboratories – V.90, V.34, V.32BIS ISOMODEM® CHIPSET WITH INTEGRATED GLOBAL DAA

Si2456/33/14
Table 12. Result Codes
Numeric¹
Meaning
Verbal Response
X0 X1 X2 X3 X4 X5
0 Command was successful OK
XXXXXX
1 Link established at 300 bps CONNECT
or higher
XXXXXX
2
Incoming ring detected
RING
XXXXXX
3 Link dropped
NO CARRIER
XXXXXX
4 Command failed
ERROR
XXXXXX
5
Link establish at 1200
CONNECT 1200
XXXXX
6
Dial tone not present
NO DIALTONE
X
XX
7
Line busy
BUSY
XXX
9 Ringback detected
RINGING
X
10 Link established at 2400 CONNECT 2400
XXXXX
11 Link established at 4800 CONNECT 4800
XXXXX
12 Link established at 9600 CONNECT 9600
14 Link established at 19200 CONNECT 19200²
XXXXX
XXXXX
15 Link established at 7200 CONNECT 7200
XXXXX
16 Link established at 12000 CONNECT 12000
XXXXX
17 Link established at 14400 CONNECT 14400
18 Link established at 16800 CONNECT 16800²
19 Link established at 21600 CONNECT 21600²
20 Link established at 24000 CONNECT 24000²
21 Link established at 26400 CONNECT 26400²
22 Link established at 28800 CONNECT 28800²
23 Link established at 31200 CONNECT 31200²
24 Link established at 33600 CONNECT 33600²
XXXXX
XXXXX
XXXXX
XXXXX
XXXXX
XXXXX
XXXXX
XXXXX
30 Caller ID mark detected
CIDM
XXXXXX
75 Link established at 75
CONNECT 75
XXXXX
31 Hookswitch flash detected FLASH
XXXXXX
32 UK CID State Tone Alert STAS
Signal detected
33 Overcurrent condition
X³
XXXXXX
XXXXXX
40 Blacklist is full
BLACKLIST FULL (enabled
via S42 register)
XXXXXX
41 Attempted number is black- BLACKLISTED (enabled via X X X X X X
listed.
S42 register)
42 No phone line present
NO LINE (enabled via %Vn
commands)
XXXXXX
Notes:
1. Numeric result codes are of the format: Result code <CR>.
2. This message is only supported on the Si2456 and Si2433.
3. X is the only verbal response code that does not follow the <CR><LF>Result Code<CR><LF> standard. There is no
leading <CR><LF>.
4. This message is only supported on the Si2456.
Rev. 1.2
35