CP2103-EK Datasheet, PDF (2/8 Pages) Silicon Laboratories – EVALUATION KIT USERS GUIDE

CP2103-EK
location. The default installation directory is C:\SiLabs\MCU\USBXpress_SDK.
Further installation instructions for the WinCE drivers can be found in the ReadMe.txt file contained inside the
driver package.
4. CP2103 Hardware Interface
The evaluation board is connected to a PC as shown in Figure 1.
1. Connect one end of the USB cable to a USB Port on the PC.
2. Connect the other end of the USB cable to the USB connector on the CP2103 evaluation board.
3. Connect one end of the RS232 serial cable to the DB-9 connector on the CP2103 evaluation board.
4. Connect the other end of the RS232 serial cable to the target serial device.
1
2
USB
CP2103 USB-to-
UART Bridge
CP2103 EK
RS232
3
4
Serial Device
Figure 1. Hardware Setup
2
Rev. 0.4