|
AN230 Datasheet, PDF (1/42 Pages) Silicon Laboratories – Device initialization sequence and busmode selection | |||
|
AN230
Si4700/01/02/03 PROGRAMMING GUIDE
1. Introduction
1.1. Scope
This document applies to Si4700/01/02/03 firmware revision 15 and greater and example code version 2 and
greater. Refer to www.mysilabs.com for example code.
1.2. Purpose
The purpose of this programming guide is to describe the following:
ï® Device initialization sequence and busmode selection
ï® 2-wire and 3-wire busmodes
ï® Step-by-step procedures for
ï¬ï setting default configuration
ï¬ï channel selection
ï¬ï seek up/seek down
ï¬ï RDS/RBDS
This document references the Si4700/01 and Si4702/03 data sheets.
1.3. Terminology
SENB or SENâserial enable pin, active low, used only for 3-wire operation
SDIOâserial data in/data out pin.
SCLKâserial clock pin.
RSTB or RSTâreset pin, active low
Deviceârefers to the Si4700/01/02/03
Rev. 0.9 6/09
Copyright © 2009 by Silicon Laboratories
AN230
|
▷ |