1611165 Datasheet, PDF (1/2 Pages) Silicon Laboratories – The addition of automotive devices in the product selection table and ordering information

Bulletin #1611165
_____________________________________________________________________________________________________
User Registration
Register today to create your account on Silabs.com. Your personalized profile allows you to receive
technical document updates, new product announcements, “how-to” and design documents, product
change notices (PCN) and other valuable content available only to registered users.
http://www.silabs.com/profile
Bulletin Date: 11/16/2016
Bulletin Effective Date: 11/16/2016
Title: EFM8SB1 Datasheet update V1.3
Bulletin Details
Description:
Silicon Labs is pleased to announce version 1.3 of the EFM8SB1 datasheet. The release corresponds to
the launch of the EFM8SB1 Automotive grade devices.
Summary of changes:
- The addition of automotive devices in the product selection table and ordering information.
- Addition of AEC-Q100 under the key features and specifications.
- Added a table on SMbus timing and operating frequency in master mode. The table details minimum
and maximum operating frequency for each class, hold times, start times, clock low and clock high
periods, and start and stop conditions.
- Added a brief table on the pins used by the bootloader and a reference to AN945 bootloader application
note.
- Added typical Cyclic Redundancy Check (CRC) Calculation Time for a read or write of a 256 byte block
of flash at 24.5 MHz.
- Added a note linking to the output low voltage and output high voltage table of the port I/Os to the
performance curves.
- Added a section describing the typical connection for debugging EFM8SB1. This includes pin sharing
techniques of the C2 interface; refer to section 5.2 of the datasheet for more information.
- Added Power-On Reset Threshold and Power-On Reset Delay specifications for a finite Vdd value and
delay times.
- Specified in the UART0 description that it has a single-byte FIFO for transmit and receive.
- Added a note on the sleep power mode that entering sleep mode may disconnect the active debug
session.
- Added a line in the introduction section to mention the reference manual where an individual can find
more technical information on registers and blocks.
Reason:
EFM8SB1 v1.3 datasheet release
Product Identification:
EFM8SB10F8A-A-QFN20
EFM8SB10F8A-A-QFN24
EFM8SB10F8A-A-QFN20R
EFM8SB10F8A-A-QFN24R
EFM8SB10F4G-A-QFN20
EFM8SB10F4G-A-QFN20R
EFM8SB10F8A-A-QFN20
EFM8SB10F8A-A-QFN20R
EFM8SB10F8A-A-QFN24
EFM8SB10F8A-A-QFN24R
W7206F2 Silicon Labs Bulletin rev R
The information contained in this document is PROPRIETARY to Silicon Laboratories, Inc. and shall not be reproduced or used in part
or whole without Silicon Laboratories’ written consent. The document is uncontrolled if printed or electronically saved. Pg 3