S24C32C Datasheet, PDF (8/35 Pages) Seiko Instruments Inc – FOR AUTOMOTIVE 105°C OPERATION

FOR AUTOMOTIVE 105°C OPERATION 2-WIRE SERIAL E²PROM
S-24C32C/64C H Series
Rev.2.1_00_H
 Pin Functions
1. A0, A1 and A2 (Slave address input) pins
In the S-24C32C/64C, to set the slave address, connect each pin of A0, A1, A2 to GND or V_CC. Therefore the users
can set 8 types of slave address by a combination of A0, A1, A2 pins.
Comparing the slave address transmitted from the master device and one that you set, makes possible to select the
S-24C32C/64C from other devices connected onto the bus.
Each A0, A1 and A2 pin has a pull-down resistor. In open, these pins have the status when they are connected to
GND.
2. SDA (Serial data input / output) pin
The SDA pin is used for the bi-directional transmission of serial data. This pin is a signal input pin, and an Nch open
drain output pin.
In use, generally, connect the SDA line to any other device which has the open-drain or open-collector output with
Wired-OR connection by pulling up to V_CC by a resistor (Figure 7 shows the relation with an output load).
3. SCL (Serial clock input) pin
The SCL pin is used for the serial clock input. Since the signals are processed at a rising or falling edge of the SCL
clock, pay attention to the rising and falling time and comply with the specification.
4. WP (Write protect input) pin
The write protect is enabled by connecting the WP pin to V_CC. When not using the write protect, connect this pin to
GND or set in open.
20
18
16
14
Maximum value of 12
pull-up resistor 10
[kΩ]
8
6
4
2
0
10
f_SCL = 400 kHz
100
Value of load capacity
[pF]
Figure 7 Output Load
8
Seiko Instruments Inc.