S-35390A Datasheet, PDF (3/54 Pages) Seiko Instruments Inc – 2-WIRE REAL-TIME CLOCK

Rev.2.4_00
2-WIRE REAL-TIME CLOCK
S-35390A
„ Pin Function
• SDA (I/O for serial data) pin
This pin is to data input/output for I²C-bus interface. This pin inputs/outputs data by synchronizing with a clock pulse
from the SCL pin. This pin has CMOS input and Nch open drain output. Generally in use, pull up this pin to the VDD
potential via a resistor, and connect it to any other device having open drain or open collector output with wired-OR
connection.
• SCL (input for serial clock) pin
This pin is to input a clock pulse for I²C-bus interface. The SDA pin inputs/outputs data by synchronizing with the clock
pulse.
• XIN, XOUT (crystal oscillator connect) pin
Connect a crystal oscillator between XIN and XOUT.
• INT1 (output for interrupt signal 1) pin
This pin outputs a signal of interrupt, or a clock pulse. By using the status register 2, users can select either of; alarm 1
interrupt, output of user-set frequency, per-minute edge interrupt, minute-periodical interrupt 1, minute-periodical
interrupt 2, or 32.768 kHz output. This pin has Nch open drain output.
• INT2 (output for interrupt signal 2) pin
This pin outputs a signal of interrupt, or a clock pulse. By using the status register 2, users can select either of; alarm 2
interrupt, output of user-set frequency, per-minute edge interrupt or minute-periodical interrupt 1. This pin has Nch open
drain output.
• VDD (positive power supply) pin
Connect this VDD pin with a positive power supply. Regarding the values of voltage to be applied, refer to “„
Recommended Operation Conditions”.
• VSS pin
Connect this VSS pin to GND.
„ Equivalent Circuits of I/O Pin
SDA
SCL
Figure 4 SDA Pin
INT1, INT2
Figure 5 SCL Pin
Figure 6 INT1 Pin, INT2 Pin
Seiko Instruments Inc.
3