S-35199A01 Datasheet, PDF (29/54 Pages) Seiko Instruments Inc – 3-WIRE REAL-TIME CLOCK

Rev.1.0_00
3-WIRE REAL-TIME CLOCK
S-35199A01
3. Per-minute edge interrupt output
Per-minute edge interrupt output is the function to output “L” from the INT pin, when the first minute-carry processing is
done, after selecting the output mode. To set the pin output to “H”, set “0” in INT1ME in the status register 2 to turn off the
output mode of per-minute edge interrupt.
Status register 2 setting
• 32kE = 0, INT1AE = Don’t care (0 or 1), INT1FE = 0
Change by program
INT1ME
Minute-carry processing _OFF
Minute-carry
processing
INT pin
"L" is output again if this period is within 7.9 ms^*1.
*1. Pin output is set to “H” by disabling the output mode within 7.9 ms, because the signal of this procedure is
maintained for 7.9 ms. Note that pin output is set to “L” by setting enable the output mode again.
Figure 34 Timing of Per-Minute Edge Interrupt Output
4. Minute-periodical interrupt output 1
The minute-periodical interrupt 1 is the function to output the one-minute clock pulse (Duty 50%) from the INT pin, when
the first minute-carry processing is done, after selecting the output mode.
Status register 2 setting
• 32kE = 0, INT1AE = 0
Change by program (OFF)
INT1FE,
INT1ME
Minute-carry
processing
Minute-carry
processing
Minute-carry
processing
Minute-carry
processing
Minute-carry
processing
INT pin
30 s 30 s 30 s 30 s 30 s 30 s 30 s 30 s 30 s
"L" is output again if this period is within 7.9 ms^*1.
"H" is output again if this period is within 7.9 ms.
"L" is output in the next minute-carry processing
*1. Setting the output mode disable makes the pin output “H”, while the output from the INT pin is in “L”. Note
that pin output is set to “L” by setting enable the output mode again.
Figure 35 Timing of Minute-periodical Interrupt Output 1
Seiko Instruments Inc.
29