S93S46A Datasheet, PDF (13/25 Pages) Seiko Instruments Inc – 3-WIRE SERIAL E2PROM FOR AUTOMOTIVE

Rev.2.1_00
150°C OPERATION 3-WIRE SERIAL E²PROM FOR AUTOMOTIVE
S-93S46A/56A/66A
4. 3 Erasing data (ERASE)
To erase 16-bit data at a specified address, set all 16 bits of the data to "1", change the CS pin to "H", and then
input the ERASE instruction and address following the start bit. There is no need to input data. The data erase
operation starts when the CS pin goes to "L". When the clocks more than the specified number have been input,
the clock pulse monitoring circuit cancels the ERASE instruction. For details of the clock pulse monitoring circuit,
refer to " Function to Protect Against Write due to Erroneous Instruction Recognition".
t_CDS
CS
Verify
Standby
SK
1 2 34 5 67 8 9
DI
<1> _{1 1} A5 A4 A3 A2 A1
A0
High-Z
DO
t_SV
busy
ready
t_HZ1
t_PR
High-Z
Figure 6 Data Erase Timing (S-93S46A)
CS
t_CDS
Verify
Standby
SK
1 2 3 4 5 6 7 8 9 10 11
DI
<1> 1 1
A6 A5 A4 A3 A2 A1 A0
DO
High-Z
x:S-93S56A
A7:S-93S66A
t_SV
busy
ready
t_HZ1
t_PR
High-Z
Figure 7 Data Erase Timing (S-93S56A/66A)
Seiko Instruments Inc.
13