FZL4145D Datasheet, PDF (1/10 Pages) Siemens Semiconductor Group – Quad Driver Incl. Short-Circuit Signaling

Quad Driver Incl. Short-Circuit Signaling
Bipolar IC
Features
q Short-circuit shutdown with clock generator
q Four driver circuits for controlling
power transistors
q Overload and short-circuit signaling
FZL 4145 D
P-DIP-18-1
Type
FZL 4145 D
Ordering Code
Q67000-H8437
Package
P-DIP-18-1
General Description
The IC comprises four driver circuits capable of driving power transistors for high output
currents. The output transistors are protected against short-circuit to ground and supply
voltage. The input threshold can be adjusted between 1.5 V and 7 V. Overload or short-
circuit failure at an output will be indicated at pin SQ (signaling output).
Functional Description
Each driver circuit has one active high driver input Dl and a common enable input (ENA)
(active high) is provided for all stages. The (Q) outputs are designed to drive the output
transistors. The load current is sampled via pin W. If the load current exceeds the preset
value, the output stage switches off. Switching-on again is provided by the built-in clock
generator. Its operation requires an external capacitor C_T at pin C. If C_T is bridged by a
break-key, switching on can only be carried out by operating a key. The duty cycle of the
clock generator is 1:50 (e.g. 40 µs/2 ms with C_T = 33 nF).
In case of overcurrent or short-circuit failure at any output stage the signaling output
(SQ) will go low. In clock-governed operation (i.e. when there is automatic switching on
by the clock and not by a key), SQ goes high and low at the clock rate as long as a short-
circuit or overload exists. SQ is an open-collector output.
Unused W pins must be connected to V_s. Open W pins would simulate a short-circuit and
activate the signaling output.
Semiconductor Group
1
09.94