WL9L-3P2432S01 Datasheet, PDF (3/6 Pages) SICK AG – Photoelectric retro-reflective sensor, autocollimation

Mechanics/electronics
Supply voltage:
Ripple:
Power consumption:
Output type:
1)
10 V DC ... 30 V DC
< 5 Vpp ²⁾
3)
≤ 30 mA
PNP ⁴⁾
Output function:
Switching mode:
Complementary
Light/dark switching ⁵⁾
Output current Imax.:
Response time:
Switching frequency:
≤ 100 mA
≤ 0.5 ms ⁶⁾
7)
1,000 Hz
Connection type:
Circuit protection:::
M12, 4-pin male connector
8) 9) 10)
A, B, C
Protection class:
III
Weight:
13 g
Polarisation filter:
ü
Special device:
ü
Optics material:
PMMA
Enclosure rating:
IP 66
IP 67
IP 69K
Ambient operating temperature:
-10 °C ... +50 °C
Ambient storage temperature:
Ambient operating temperature extended::
-30 °C ... +70 °C
-30 °C ... +55 °C ^{11) 12)}
UL File No.:
NRKH.E181493
Housing material:
Plastic, VISTAL
1)
2)
3)
4) 5)
6)
Limit values, operation in short-circuit protected network max. 8 A May not exceed or fall short of V tolerances Without load
Q = light-switching Signal
7)
8)
S ₉₎
10)
transit time with resistive load With light/dark ratio 1:1 A = V connections reverse-polarity protected B = inputs and output reverse-polarity protected C =
11)
S
12)
interference suppression As of T = 50 °C, a max. supply voltage V = 24 V and a max. load current I = 50 mA is permitted Using the sensor below T
a
max.
max.
a
= -10 °C is possible, if the sensor is turned on at T > -10 °C, then the environment cools down and the sensor is not disconnected from the supply voltage during the
a
whole time. It is not allowed to turn on the sensor below T = -10 °C
a
Photoelectric sensorsAAAAAAAAAAAAA© SICK AG. Subject to change without notice.AAAAAAAAAAAAA2/25/2016 1:38:52 AM