English
Language : 

C4P-EA19530A001100 Datasheet, PDF (3/10 Pages) SICK AG – SAFETY LIGHT CURTAINS
C4P-SA19530A001100, C4P-EA19530A001100 | deTec4 Prime
SAFETY LIGHT CURTAINS
Functions
Functions
Restart interlock
✔
External device monitoring (EDM)
✔
Beam coding
✔
Automatic calibration of the protective field ✔
width
Delivery status
Deactivated
Deactivated
Uncoded
Interfaces
System connection
Connection type Male connector M12, 5-pin
Flexi-Loop-ready ✔
Sender/receiver communication (COM1) ✔ 1)
Permitted cable length Receiver power supply: 15 m 2)
All additional conductors at the system connection: 37.5 m
Extension connection
Connection type Female connector M12, 5-pin
Reset pushbutton input (RES) ✔ 3)
External device monitoring input (EDM) ✔ 3)
Application diagnostic output (ADO) ✔ 3)
Permitted cable length ≤ 10 m
Configuration method
Cascade Automatic detection when starting the device
External device monitoring (EDM) Automatic detection when starting the device
Calibration of the protective field width Automatic detection when starting the device
Restart interlock Teach-in procedure when starting the device
Beam coding DIP switch
Reset to factory default DIP switch
Status display
LEDs
Fieldbus, industrial network
Integration via Flexi Soft safety controller CANopen, DeviceNet™, EtherCAT®, EtherNet/IP™, Modbus TCP, PROFIBUS DP, PROFINET 4)
1) Optional: To indicate the status on both sides, the COM1 connections from the sender and receiver must be connected to each other in the control cabinet.
2) If no inductive OSSD loads (e.g., contactors) are in use, the power supply cable for the receiver of a single device (no cascade) can be up to 30 m in length.
3) Single device or last guest (receiver only).
4) For additional information on Flexi Soft -> www.sick.com/Flexi_Soft.
Electrical data
Protection class
Supply voltage VS
Ripple
Power consumption typical
III (EN 50178) 1)
24 V DC (19.2 V DC ... 28.8 V DC)
≤ 10 % 2)
3.96 W (DC) / 2.05 W (DC) (depending on type)
1) SELV/PELV safety/protective extra-low voltage.
2) Within the limits of VS.
3) Applies to the voltage range between –30 V and +30 V.
2017-08-21 16:38:06 | Online data sheet
S ubject to change without notice
OPTO-ELECTRONIC PROTECTIVE DEVICES | SICK
3